Skip to contentSkip to conversation

Bluetooth: hci_sync: Fix not updating privacy_mode

PATCH Applied Luiz Augusto von Dentz 3 participants 4 messages Jul 14, 2022 – Jul 18, 2022

Subsystems (2)
lore
Share & tools
lore

Luiz Augusto von Dentz

author maintainer
#0 lore raw

PATCH v2 1/2 Bluetooth: hci_sync: Fix not updating privacy_mode

From: Luiz Augusto von Dentz <[email protected]>

When programming a new entry into the resolving list it shall default to network mode since the params may contain the mode programmed when the device was last added to the resolving list.

Fixes 853b70b506a20 ("Bluetooth: hci_sync: Set Privacy Mode when updating the resolving list")

---
v2: Use HCI_NETWORK_PRIVACY instead of 0x00

 net/bluetooth/hci_sync.c | 3 +++
 1 file changed, 3 insertions(+)
net/bluetooth/hci_sync.c +3 -0
index ca97378fd81f..256ece5640b7 100644
@@ -1636,6 +1636,9 @@ static int hci_le_add_resolve_list_sync(struct hci_dev *hdev,
 	bacpy(&cp.bdaddr, &params->addr);
 	memcpy(cp.peer_irk, irk->val, 16);
 
+	/* Default privacy mode is always Network */
+	params->privacy_mode = HCI_NETWORK_PRIVACY;
+
 done:
 	if (hci_dev_test_flag(hdev, HCI_PRIVACY))
 		memcpy(cp.local_irk, hdev->irk, 16);
Signature · 1 line
2.35.3
author maintainer
#1 lore raw

PATCH v2 2/2 Bluetooth: hci_sync: Don't remove connected devices from accept list

From: Luiz Augusto von Dentz <[email protected]>

These devices are likely going to be reprogrammed when disconnected so this avoid a whole bunch of commands attempt to remove and the add back to the list.

---
 net/bluetooth/hci_sync.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)
net/bluetooth/hci_sync.c +5 -2
index 256ece5640b7..c746714f218f 100644
@@ -1892,12 +1892,15 @@ static u8 hci_update_accept_list_sync(struct hci_dev *hdev)
 	}
 
 	/* Go through the current accept list programmed into the
-	 * controller one by one and check if that address is still
-	 * in the list of pending connections or list of devices to
+	 * controller one by one and check if that address is connected or is
+	 * still in the list of pending connections or list of devices to
 	 * report. If not present in either list, then remove it from
 	 * the controller.
 	 */
 	list_for_each_entry_safe(b, t, &hdev->le_accept_list, list) {
+		if (hci_conn_hash_lookup_le(hdev, &b->bdaddr, b->bdaddr_type))
+			continue;
+
 		pend_conn = hci_pend_le_action_lookup(&hdev->pend_le_conns,
 						      &b->bdaddr,
 						      b->bdaddr_type);
Signature · 1 line
2.35.3
#2 lore raw
In reply to Luiz Augusto von Dentz

This is automated email and please do not reply to this email!

Dear submitter,

Thank you for submitting the patches to the linux bluetooth mailing list. This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=659825

---Test result---

Test Summary:

CheckPatch                    PASS      1.84 seconds
GitLint                       PASS      0.88 seconds
SubjectPrefix                 PASS      0.57 seconds
BuildKernel                   PASS      38.85 seconds
BuildKernel32                 PASS      34.10 seconds
Incremental Build with patchesPASS      56.43 seconds
TestRunner: Setup             PASS      576.79 seconds
TestRunner: l2cap-tester      PASS      18.82 seconds
TestRunner: bnep-tester       PASS      6.65 seconds
TestRunner: mgmt-tester       PASS      112.16 seconds
TestRunner: rfcomm-tester     PASS      10.48 seconds
TestRunner: sco-tester        PASS      10.12 seconds
TestRunner: smp-tester        PASS      10.37 seconds
TestRunner: userchan-tester   PASS      6.86 seconds

---
Regards,
Linux Bluetooth

#3 lore raw
In reply to Luiz Augusto von Dentz
This series was applied to bluetooth/bluetooth-next.git (master) by Luiz Augusto von Dentz <[email protected]>:

Hello:

This series was applied to bluetooth/bluetooth-next.git (master) by Luiz Augusto von Dentz <[email protected]>:

Quoted 6 lines · On Thu, 14 Jul 2022 11:12:23 -0700 you wrote:

From: Luiz Augusto von Dentz <[email protected]>

When programming a new entry into the resolving list it shall default to network mode since the params may contain the mode programmed when the device was last added to the resolving list.

Quoted 6 lines
Fixes 853b70b506a20 ("Bluetooth: hci_sync: Set Privacy Mode when updating the resolving list")

[...]

Here is the summary with links:
- [v2,1/2] Bluetooth: hci_sync: Fix not updating privacy_mode

    https://git.kernel.org/bluetooth/bluetooth-next/c/ab345b04433d
  - [v2,2/2] Bluetooth: hci_sync: Don't remove connected devices from accept list
    https://git.kernel.org/bluetooth/bluetooth-next/c/ff1688aab0d1

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html