clk: qcom: gcc-ipq6018: add qdss_at clock needed for wifi operation
Subsystems (3)
PATCH v2 1/1 clk: qcom: gcc-ipq6018: add qdss_at clock needed for wifi operation
Without it system hangs upon wifi firmware load. It should be enabled by remoteproc/wifi driver. Bindings already exist for it, so add it based on vendor code.
Signed-off-by Mantas Pucka <[email protected]>
---
Changes in v2:
Remove CLK_IS_CRITICAL flag
Note in commit message that clock should be enabled by remoteproc driver
drivers/clk/qcom/gcc-ipq6018.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)
drivers/clk/qcom/gcc-ipq6018.c +17 -0
@@ -3522,6 +3522,22 @@ static struct clk_branch gcc_prng_ahb_clk = { }, }; +static struct clk_branch gcc_qdss_at_clk = { + .halt_reg =0x29024 , + .clkr = { + .enable_reg =0x29024 , + .enable_mask =BIT (0 ), + .hw.init = &(struct clk_init_data ){ + .name ="gcc_qdss_at_clk" , + .parent_hws = (const struct clk_hw *[]){ + &qdss_at_clk_src.clkr.hw }, + .num_parents =1 , + .flags =CLK_SET_RATE_PARENT , + .ops = &clk_branch2_ops, + }, + }, +}; +static struct clk_branch gcc_qdss_dap_clk = { .halt_reg =0x29084 , .clkr = {
@@ -4361,6 +4377,7 @@ static struct clk_regmap *gcc_ipq6018_clks[] = { [GCC_SYS_NOC_PCIE0_AXI_CLK] = &gcc_sys_noc_pcie0_axi_clk.clkr, [GCC_PCIE0_PIPE_CLK] = &gcc_pcie0_pipe_clk.clkr, [GCC_PRNG_AHB_CLK] = &gcc_prng_ahb_clk.clkr, + [GCC_QDSS_AT_CLK] = &gcc_qdss_at_clk.clkr, [GCC_QDSS_DAP_CLK] = &gcc_qdss_dap_clk.clkr, [GCC_QPIC_AHB_CLK] = &gcc_qpic_ahb_clk.clkr, [GCC_QPIC_CLK] = &gcc_qpic_clk.clkr,
Signature · 1 line
2.7.4
Quoted 5 lines · Mantas Pucka
Without it system hangs upon wifi firmware load. It should be enabled by remoteproc/wifi driver. Bindings already exist for it, so add it based on vendor code.
Applied, thanks!
[1/1] clk: qcom: gcc-ipq6018: add qdss_at clock needed for wifi operation
commit: fd712118aa1aa758da1fd1546b3f8a1b00e42cbc
Best regards,
Signature · 1 line
Bjorn Andersson <[email protected]>