XLlTemac port forwarding probelm?

Hi everyone,

I'm using my custom Xilinx board as a gateway for a networked webcam. The board is based on the ml410. Basically eth1 is connected to the outside world and eth0 is connected to the webcam. I'm port forwarding port 80 with iptables. I can connect to the webcams web server by going to the IP address of the Xilinx board just fine, but here comes my problem...

After the first initial load, which is relatively fast, all subsequent refreshes become ungodly slow. If I ifconfig down eth1 and bring it back up the next refresh is fast again.

I'm using Xilinx's Local Link Mac with the Fifo interface instead of DMA. Any ideas of whats going on?

Thanks

Kevin

View this message in context: http://www.nabble.com/XLlTemac-port-forwarding-probelm--tp17611404p17611404.html
Sent from the linuxppc-embedded mailing list archive at Nabble.com.