Skip to contentSkip to conversation

EPIA-M: DMA & VT8235 Lock-up

DISCUSSION [email protected] 1 participant 1 message Apr 4, 2006

lore
Share & tools
lore
#0 lore raw

Hi,

I am writing to this list since I think solving this issue may have some importance also to other Linux users.

Please CC me if you answer since I am not subscribed to this list!

Here is the issue:

I have severe lock-ups with Vias ME6000 motherboard with UDMA100 transfers.

MY Hardaware:

VIA EPIA ME6000 (VIA VT8235 south bridge)
512 MB DDR400 RAM (verified OK!)
Technotrend DVBs 1.5 card
Intel Pro 1000 desktop ethernet card (e1000)
Linux Kernel 2.6.13
Bios: 1.16
hard drive Samsung HM100JC (UDMA 100 capable)

I made some test copying some files back and forth on my HD

When I run this in dma4 and dma5 mode my systems stops working after a while.
With lower DMA modes or in PIO mode everything is fine.
I tested already different 80 pin ATA cables, but the cable does not solve the problem.

So the board or the drivers have a DMA issue.

I am wondering if this can be fixed in the LINUX Kernel or if this is an unsolved VT8235 hardware issue.

Lockups usually occur if there is also other traffic, like network traffic.
Via seems to have a solution for its Windows drivers since it has been reported that with a driver update in 2005 the issue was solved.

Others users report similar problems. See related thread here:

http://forums.viaarena.com/messageview.aspx?catid=28&threadid=60131&STAR
TPAGE=1&FTVAR_FORUMVIEWTMP=Linear

Are there any suggestions if this can be fixed by modifying kernel divers?

RGDS

Christian