Skip to contentSkip to conversation

flow_dissector: check device type before reading ETH_ADDRS

PATCH Applied Yun Zhou 2 participants 2 messages Jun 16 – Jun 19

Subsystems (2)
lore
Share & tools
lore

Yun Zhou

author
#0 lore raw

PATCH v4 1/1 flow_dissector: check device type before reading ETH_ADDRS

__skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb) when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb has a valid Ethernet header at mac_header, which is not always the case.

The problem can be triggered by:
1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)
2. Attaching a multiq qdisc with a flower filter matching on eth_src
3. Sending a packet through AF_PACKET

Since TUN in L3 mode has no link-layer header, mac_header points to the L3 data area. The flow dissector reads 12 bytes of uninitialized skb memory, which then propagates through fl_set_masked_key() and is used as a rhashtable lookup key in __fl_lookup(), as reported by KMSAN.

Rejecting the filter in the control path (at tc filter add time) is not feasible because TC filter blocks can be shared between arbitrary devices -- a filter installed on an Ethernet device may later classify packets on a headerless device through a shared block. The device association is not fixed at filter creation time.

Fix this by gating the memcpy on dev->type == ARPHRD_ETHER, which ensures only true Ethernet-framed packets have their addresses read. This is more precise than the previous hard_header_len >= 12 check, which would incorrectly pass for non-Ethernet link types like IPoIB (ARPHRD_INFINIBAND, hard_header_len=24) and FDDI (hard_header_len=21) whose L2 headers are not in Ethernet format. Additionally check skb_mac_header_was_set() to guard against the pathological case where mac_header is the unset sentinel (~0U), which would cause eth_hdr() to return a wild pointer.

For the act_mirred redirect case (Ethernet packet redirected to a non-Ethernet device sharing a TC block), zeroing the key is the correct
behavior: the packet is now being classified on the target device, where Ethernet address matching is not semantically meaningful.

Note: on non-Ethernet devices, the zeroed key will match a filter configured with all-zero MAC addresses. This is an improvement over the previous behavior where uninitialized memory could randomly match any filter.

Reported-by [email protected]
Fixes 67a900cc0436 ("flow_dissector: introduce support for Ethernet addresses")

---
v4:
- Use dev->type == ARPHRD_ETHER instead of hard_header_len >= 12 to avoid false positives on non-Ethernet link types (IPoIB, FDDI)
- Add skb_mac_header_was_set() guard against unset mac_header sentinel
- Document act_mirred and all-zero key edge cases in commit message

v3:
- Replace skb_tail_pointer() - skb_mac_header() length check with

    skb->dev->hard_header_len check.

v2:
- Adjust commit message and comment.

 net/core/flow_dissector.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)
net/core/flow_dissector.c +10 -2
index 2a98f5fa74eb..8aa4f9b4df81 100644
@@ -1173,13 +1173,21 @@ bool __skb_flow_dissect(const struct net *net,
 
 	if (dissector_uses_key(flow_dissector,
 			       FLOW_DISSECTOR_KEY_ETH_ADDRS)) {
-		struct ethhdr *eth = eth_hdr(skb);
 		struct flow_dissector_key_eth_addrs *key_eth_addrs;
 
 		key_eth_addrs = skb_flow_dissector_target(flow_dissector,
 							  FLOW_DISSECTOR_KEY_ETH_ADDRS,
 							  target_container);
-		memcpy(key_eth_addrs, eth, sizeof(*key_eth_addrs));
+		/* TC filter blocks can be shared across devices with
+		 * different link types, so we cannot validate this
+		 * when the filter is installed -- check at dissect time.
+		 */
+		if (skb && skb->dev &&
+		    skb->dev->type == ARPHRD_ETHER &&
+		    skb_mac_header_was_set(skb))
+			memcpy(key_eth_addrs, eth_hdr(skb), sizeof(*key_eth_addrs));
+		else
+			memset(key_eth_addrs, 0, sizeof(*key_eth_addrs));
 	}
 
 	if (dissector_uses_key(flow_dissector,
Signature · 1 line
2.43.0
#1 lore raw
This patch was applied to netdev/net.git (main) by Jakub Kicinski <[email protected]>:

Hello:

This patch was applied to netdev/net.git (main)
by Jakub Kicinski <[email protected]>:

Quoted 10 lines · On Tue, 16 Jun 2026 20:30:57 +0800 you wrote:

__skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb) when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb has a valid Ethernet header at mac_header, which is not always the case.

The problem can be triggered by:
1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)
2. Attaching a multiq qdisc with a flower filter matching on eth_src
3. Sending a packet through AF_PACKET

[...]

Here is the summary with links:
- [v4] flow_dissector: check device type before reading ETH_ADDRS

    https://git.kernel.org/netdev/net/c/bf6e8af2c8be

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html