Skip to contentSkip to conversation

kernel bootable again

i386 BOOT CODE Etienne Lorrain 1 participant 1 message Sep 20, 2005

lore
Share & tools
lore
#0 lore raw
Quoted 7 lines
Quoted 4 lines
Quoted 4 lines
Quoted 4 lines

So if the "something" knows (or can get to know) the sector/tracks layout of the disk it's writing the kernel onto, it could store this information in the bootblock (is there space for that?). The bootblock code would then just read this info and use it.

Actually, DOS/Windows works that way. FAT filesystem stores the number of sectors per track in its boot sector.

Gujin installer creates the filesystem (and the partition table if
needed), the MBR with the disk geometry, and chain a simple bootloader or a menu based bootloader on the created FAT filesystem when told to do so.

So if you just want to put a kernel and initrd on a floppy, and the
floppy is big enough, you just do:

$ mkdir tmp
$ cd tmp
$ wget http://heanet.dl.sourceforge.net/sourceforge/gujin/install-1.2.tar.gz
$ tar xvzf install-1.2.tar.gz
$ ./instboot tiny.bin /dev/fd0
$ mcopy /boot/vmlinuz-2.6.13 a:
$ mcopy /boot/initrd-2.6.13 a:
  And you reboot with the floppy still inside the drive.

If you want to put them on your USB thumb drive, and your PC can
boot USB flash drives as a floppy (lot of BIOS bugs there), you just change the line (double check that your USB key is /dev/sda):

$ ./instboot tiny.bin /dev/fd0
  by:
$ ./instboot tiny.bin /dev/sda --disk=BIOS:0x00 --geometry=/dev/sda

I personnally better like a partition table on my USB drives, so
I am more used to erase manually the partition table:

$ dd if=/dev/null of=/dev/sda bs=512 count=64 # blank the head of the disk
 and then type:
$ ./instboot boot.bin /dev/sda --disk=BIOS:0x00 --geometry=/dev/sda \
     --mbr-device=/dev/sda --partition_index=1

When booted from this key, the PC will boot the kernel named vmlinuz*
and load the initrd/initramfs named initrd* (tiny.bin does not contain the graphic menu management).

I will not say that I tested it lately, but you may also want to put
your kernel and initrd on a bootable CDROM - without having the usual Gujin menu - then you just do:

$ mkdir tmpdir
$ cp /boot/vmlinuz-2.6.13 tmpdir
$ cp /boot/initrd-2.6.13 tmpdir
$ ./instboot tiny.bin tmpdir/tiny.bcd
$ mkisofs -untranslated-filenames -no-emul-boot -boot-load-size 4 \
    -b tiny.bcd tmpdir -o boot.iso
$ cdrecord boot.iso

It is usually better (and will work for all those configuration)
to put the kernel and its initrd inside a directory named "/boot", but I am highjicking a thread so want to keep it simple...

Etienne.