u-boot nand suppoort for i.MX5
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hello George,
Quoted 10 lines · George C. Huntington III
hello Beno?t,
I am trying to get a recent u-boot working with a KARO-TX53 (i.MX53 based board) and booting from nand. I have been looking at your patches
from http://article.gmane.org/gmane.comp.boot-loaders.u-boot/137806
and I am having some trouble getting nand to be recognized. do you have
a git repository with your i.MX5 nand work in it that I can pull from to
get get my board booting?
Can you try to apply the following patch to u-boot/master
(http://git.denx.de/cgi-bin/gitweb.cgi?p=u-boot.git;a=summary)?
http://patchwork.ozlabs.org/patch/179176/
http://patchwork.ozlabs.org/patch/179176/raw/
Normally, it should apply fine.
I have tested it with i.MX51 NAND boot. It should also work fine with i.MX53. Note that I used SLC with 2-kB pages. 4-kB pages should be supported by mxc nand spl, but not yet by mtd mxc.
Best regards,
Beno?t