MCP750 and CPX2000 System Scsi Woes
In message "Re: MCP750 and CPX2000 System Scsi Woes",
Quoted 8 lines · Gabriel Paubert
Not very surprising, which is the actual interrupt used for SCSI (it should be in the doc and in the residual data).
Tell me if the zImage-2.2.0-pre5 on ftp://vcorr1.iram.es/pub/ works better. Early boot messages will be different and it will try to use the OpenPIC (that's the image running on my MVME2600 right now). I'm completely reorganizing my source code and patches, hopefully I'll be able to make it available during the week-end.
Gabriel, it worked! SCSI devices were found successfully. It died at the end trying to mount the non-existent root partition. If you have a ramdisk image that contains an installer, it would be appreciated. :-) I'll look for your source on Monday.
Thanks again,
-Jim
[[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]] [[ the message 'unsubscribe' to [email protected] ]]