unresolved symbol pci_proc_init
Hi all,
compiling the current CVS kernel for a non-PCI machine like my 715/33 leads to an unresolved symbol message for pci_proc_init.
In init/main.c is the following code:
#ifdef CONFIG_GECKO
gsc_init();
/*
** pci_init() is NOT multi-PCI bus friendly.
*/
#ifdef CONFIG_PROC_FS
pci_proc_init();
#endif
#else
#ifdef CONFIG_PCI
pci_init();#endif
#endif
So pci_proc_init is included even if CONFIG_PCI is not set.
Ulrich
__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com
Quoted 19 lines · Ulrich Strelow
Hi all,
compiling the current CVS kernel for a non-PCI machine like my 715/33 leads to an unresolved symbol message for
pci_proc_init.In
init/main.cis the following code:#ifdef CONFIG_GECKO gsc_init(); /* ** pci_init() is NOT multi-PCI bus friendly. */ #ifdef CONFIG_PROC_FS pci_proc_init(); #endif #else #ifdef CONFIG_PCI pci_init();
Quoted 5 lines
#endif
#endifSo
pci_proc_initis included even ifCONFIG_PCIis not set.
Ulrich,
Apologies - that's my fault. I wasn't very clean when changing the ifdefs to invoke gsc_init(). The ifdef should read:
#if defined(CONFIG_PCI) && defined(CONFIG_PROC_FS)
...
If no one else objects, go ahead and submit that - after you try it. :^)
On the same note, the ifdefs in gsc_init() probably need to use "defined(CONFIG_PCI)" around the "dino_init()" call...
sorry,
grant
Quoted 9 lines
Ulrich
__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com---------------------------------------------------------------------------
To unsubscribe: send e-mail to [email protected] with `unsubscribe' as the subject.
Grant Grundler
Communications Infrastructure Computer Operations
+1.408.447.7253