Skip to contentSkip to conversation

2.3.45 on B&W G3 PCI-PCI Bridge scan - Is this a problem in earlier kernels?

DISCUSSION Patrick Callahan 2 participants 2 messages Feb 19, 2000 – Feb 20, 2000

lore
Share & tools
lore
#0 lore raw

Is it possible that this PCI-PCI bridge scan timing problem manifests itself in earlier kernels on Blue
G3's as intermittent boot failures? Ocasionally when I run in MacOS 8.6 for a time, and then boot into Linux using the BootX application version 1.2.? the boot gets to the point where it writes out the word booting... on the console. but no further.

Is this worth investigating and fixing in the stable kernel if it is shown to be a problem there?

Pat Callahan
Acton Ma USA
Programmer

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 9 lines · Patrick Callahan

Is it possible that this PCI-PCI bridge scan timing problem manifests itself in earlier kernels on Blue
G3's as intermittent boot failures? Ocasionally when I run in MacOS 8.6 for a time, and then boot into Linux using the BootX application version 1.2.? the boot gets to the point where it writes out the word booting... on the console. but no further.

Is this worth investigating and fixing in the stable kernel if it is shown to be a problem there?

Did you try compiling with xmon enabled in the config ? There's a small buglet in the current devel tree that can break if it's not enabled.

Also, On NewWorld machines, yaboot booting should be more reliable than BootX.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/