Skip to contentSkip to conversation

First latency test results for linuxPPC [2.2.17pre10-ben2]

linux-audio-dev Iain Sandoe 1 participant 1 message Jul 14, 2000

lore
Share & tools
lore
#0 lore raw
Quoted 3 lines · Roger Larsson
Quoted 2 lines · Iain Sandoe

I've posted the results of Benno's latency tests applied to 2.2.17pre10-ben2 on LinuxPPC.

[...]

Quoted 4 lines
Quoted 4 lines

No big surprises - although the PPC /proc fs seems to be a little slower than the x86 one...

Working on 2.4.0-test4 & thence to Andrew's patches on LinuxPPC...

[...]

Quoted 7 lines

The green ticks on X11 test are interesting - something with a higher prio than
the SCHED_FIFO max takes the processor away from it and runs for more than 1 ms.

The only thing that can do that is interrupt routines / back handlers... (try to find this one)

Yeah, I've got a concern there... I have Jun Sun's IRQ latency test code ported. I'll re-do the patch and try it again.

I have a feeling that the first time through (with the IRQ code) I may have made a mistake in the value of the freq of the VEA Timebase counter.

If this is true then the IRQ times for the PPC are truly awful on occasions..

I.E. I had the freq as 300 MHz - but I think it is actually approx 18MHz.

If that is the case then there is/are something/some things that are holding IRQs off for up to.... > 9 or so ***ms*** Yikes.

I'll check this out tomorrow... but locating them might be hard because most of the longer times are recorded in 'softira.c' & 'irq.c' - which doesn't narrow things down much.

Expect a re-do of the IRQ patch tomorrow - and a request to try it out :-)

Quoted 1 line

Disk read looks nice - others looks ...

ummm /proc was the one that looked worst to me...

Iain.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/