2.4.0-11 AIC7xxx.o driver barfs on AHA27XX adapter
On a four processor POCA system with dual Fast-SCSI AHA274X/VLB bus controllers I am seeing the following timeout errors right after the sequencer scripts are downloaded and the driver starts polling. It does not happen when compiled in kernel, only when loaded from an initrd image. The root FS is getting mounted properly and probing and loading the driver.
aborting command due to timeout: pid 00 scsi 00 channel 00 lun 00 inquiry 00 00 00 ff 00
The machine then hard hangs after it gets this error and has to be powered off in order to reboot it.
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Quoted 9 lines · Jeff V. Merkey
On a four processor POCA system with dual Fast-SCSI AHA274X/VLB bus controllers I am seeing the following timeout errors right after the sequencer scripts are downloaded and the driver starts polling. It does not happen when compiled in kernel, only when loaded from an initrd image. The root FS is getting mounted properly and probing and loading the driver.
Quoted 5 lines
aborting command due to timeout: pid 00 scsi 00 channel 00 lun 00 inquiry 00 00 00 ff 00
The machine then hard hangs after it gets this error and has to be powered off in order to reboot it.
I tested 2.2.18-24 with an initrd and works fine on the same hardware, BTW
Jeff
Quoted 7 lines
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/