Skip to contentSkip to conversation

VIA IDE 4.0 and AMD IDE 2.0 with automatic PCI clock detection

preview Philip Langdale 2 participants 2 messages Feb 9, 2001 – Feb 10, 2001

lore
Share & tools
lore
#0 lore raw

Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit

Vojtech,

I've tried out your new via driver and it appears to have solved the problem with
the mis-detected ls-120 drive, but the ata66 drives are still being run at 33.

More interestingly, the pci-clk calculations seem to be returning badly off values.

My motherboard is a kt133a+686b btk7a from abit.

When I set the FSB to 133 with PCI=133/4=33 the timing code returns 43mhz.

when I set the FSB to 100 with PCI=100/3=33 then it returns 42mhz.

These are scarely different from the nominal values. I didn't observe anything bad in the few minutes I was running like this, but right now I've hacked the driver back to a hardcoded 33.

What should I do next?

--phil
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/

#1 lore raw
Quoted 22 lines · Philip Langdale

Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit

Vojtech,

I've tried out your new via driver and it appears to have solved the problem with
the mis-detected ls-120 drive, but the ata66 drives are still being run at 33.

More interestingly, the pci-clk calculations seem to be returning badly off values.

My motherboard is a kt133a+686b btk7a from abit.

When I set the FSB to 133 with PCI=133/4=33 the timing code returns 43mhz.

when I set the FSB to 100 with PCI=100/3=33 then it returns 42mhz.

Quoted 6 lines

These are scarely different from the nominal values. I didn't observe anything bad in the few minutes I was running like this, but right now I've hacked the driver back to a hardcoded 33.

What should I do next?

Are you willing to do some experiments? I suppose the 686b is somewhat different than the other chips (I tested it on 686a and 586b).

Signature · 6 lines
Vojtech Pavlik
SuSE Labs
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/