Skip to contentSkip to conversation

SX driver patch.

PATCH Rogier Wolff 1 participant 1 message Mar 8, 2001 Char and misc drivers

lore
Share & tools
lore
#0 lore raw

Hi Alan,

A client noted that we forgot to implement breaks in the SX driver. Turns out to be easy. Moreover... I actually tested this patch! (Somehow the Makefile entry for SX got stomped on, that's fixed here too.)

Roger.

Signature · 4 lines
** [email protected] ** http://www.BitWizard.nl/ ** +31-15-2137555 **
*-- BitWizard writes Linux device drivers for any device you may have! --*
* There are old pilots, and there are bold pilots. 
* There are also old, bald pilots. 
drivers/char/Makefile +7 -1
diff -ur linux-2.2.19-pre16.clean/drivers/char/Makefile linux-2.2.19-pre16.sx/drivers/char/Makefile
@@ -200,7 +200,13 @@
   endif
 endif
 
-obj-$(CONFIG_SX) += sx.o generic_serial.o
+ifeq ($(CONFIG_SX),y)
+O_OBJS += sx.o generic_serial.o
+else
+  ifeq ($(CONFIG_SX),m)
+  M_OBJS += sx.o generic_serial.o
+  endif
+endif
 
 ifeq ($(CONFIG_RIO),y)
 O_OBJS += rio/rio.o generic_serial.o
drivers/char/sx.c +15 -1
diff -ur linux-2.2.19-pre16.clean/drivers/char/sx.c linux-2.2.19-pre16.sx/drivers/char/sx.c
@@ -1799,6 +1799,20 @@
 }
 
 
+static void sx_break (struct tty_struct * tty, int flag)
+{
+	struct sx_port *port = tty->driver_data;
+	int rv;
+
+	if (flag) 
+		rv = sx_send_command (port, HS_START, -1, HS_IDLE_BREAK);
+	else 
+		rv = sx_send_command (port, HS_STOP, -1, HS_IDLE_OPEN);
+	if (rv != 1) printk (KERN_ERR "sx: couldn't send break (%x).\n",
+			read_sx_byte (port->board, CHAN_OFFSET (port, hi_hstat)));
+}
+
+
 static int sx_ioctl (struct tty_struct * tty, struct file * filp, 
                      unsigned int cmd, unsigned long arg)
 {
@@ -1867,7 +1881,6 @@
 			sx_reconfigure_port(port);
 		}
 		break;
-
 	default:
 		rc = -ENOIOCTLCMD;
 		break;
@@ -2247,6 +2260,7 @@
 	sx_driver.table = sx_table;
 	sx_driver.termios = sx_termios;
 	sx_driver.termios_locked = sx_termios_locked;
+	sx_driver.break_ctl = sx_break;
 
 	sx_driver.open	= sx_open;
 	sx_driver.close = gs_close;