Skip to contentSkip to conversation

Promise RAID controller howto?

DISCUSSION Henning P. Schmiedehausen 5 participants 5 messages Mar 27, 2001 – Mar 29, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

I know, that this is a FAQ and the Promise RAID controller card is not yet usable as a RAID board under Linux 2.x but is there a way to use the controller just like the UltraATA 100 controller?

I know, that "input high == UltraATA core, input low = RAID core" according to Andre Hedrick but I really don't care about the RAID core. I want to use this controller to drive JBOD.

Can one do this? The disks need not to be interchangeable to other controllers. Just be accessible.

2.2 solutions preferred, 2.4 ok.

Regards
Henning

Signature · 5 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen       -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH     [email protected]

Am Schwabachgrund 22  Fon.: 09131 / 50654-0   [email protected]
D-91054 Buckenhof     Fax.: 09131 / 50654-20   
#1 lore raw
Quoted 5 lines · Henning P. Schmiedehausen

Hi,

I know, that this is a FAQ and the Promise RAID controller card is not yet usable as a RAID board under Linux 2.x but is there a way to use the controller just like the UltraATA 100 controller?

It is not a raid board ... it is a raid lie

Quoted 3 lines

I know, that "input high == UltraATA core, input low = RAID core" according to Andre Hedrick but I really don't care about the RAID core. I want to use this controller to drive JBOD.

Wrong, if Promise will opensource the signatures then we map the software raid against that location and use Linux's soft-raid.

Quoted 20 lines

Can one do this? The disks need not to be interchangeable to other controllers. Just be accessible.

2.2 solutions preferred, 2.4 ok.

Regards
Henning

Signature · 10 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen       -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH     [email protected]

Am Schwabachgrund 22  Fon.: 09131 / 50654-0   [email protected]
D-91054 Buckenhof     Fax.: 09131 / 50654-20   
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Andre Hedrick
Linux ATA Development
ASL Kernel Development
-----------------------------------------------------------------------------

ASL, Inc.                                     Toll free: 1-877-ASL-3535
1757 Houret Court                             Fax: 1-408-941-2071
Milpitas, CA 95035                            Web: www.aslab.com
#2 lore raw

Hmmmmm i have the Promise raid source for 2.2 kernel modules so what do you mean by opensource signatures

i have it working for 2.2 kernels but i can't get it to work properly in 2.4 So if someone want to look at the source !!!
it can be found on www.promise.com

Assie

Andre Hedrick schreef:

Quoted 51 lines · Henning P. Schmiedehausen
Quoted 6 lines

Hi,

I know, that this is a FAQ and the Promise RAID controller card is not yet usable as a RAID board under Linux 2.x but is there a way to use the controller just like the UltraATA 100 controller?

It is not a raid board ... it is a raid lie

Quoted 3 lines

I know, that "input high == UltraATA core, input low = RAID core" according to Andre Hedrick but I really don't care about the RAID core. I want to use this controller to drive JBOD.

Wrong, if Promise will opensource the signatures then we map the software raid against that location and use Linux's soft-raid.

Quoted 12 lines

Can one do this? The disks need not to be interchangeable to other controllers. Just be accessible.

2.2 solutions preferred, 2.4 ok.

Regards
Henning

--
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH [email protected]

Quoted 8 lines

Am Schwabachgrund 22 Fon.: 09131 / 50654-0 [email protected]
D-91054 Buckenhof Fax.: 09131 / 50654-20
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Andre Hedrick
Linux ATA Development
ASL Kernel Development
-----------------------------------------------------------------------------

ASL, Inc.                                     Toll free: 1-877-ASL-3535
1757 Houret Court                             Fax: 1-408-941-2071
Milpitas, CA 95035                            Web: www.aslab.com

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

#3 lore raw
In reply to Andre Hedrick

Hi,

as far as I can see (you're talking about the "rel.tgz" archive from the LinuxBETA directory, don't you?), this is just glue code for their binary only "ftlib.o" driver.

No real open source here. Maybe Andre can work something from the header structures. But then again, the archive is dated 9/28/2000, it's not exactly new...

Regards
Henning

Quoted 62 lines · Erik van Asselt

Hmmmmm i have the Promise raid source for 2.2 kernel modules so what do you mean by opensource signatures

i have it working for 2.2 kernels but i can't get it to work properly in 2.4 So if someone want to look at the source !!!
it can be found on www.promise.com

Assie

Andre Hedrick schreef:

Quoted 51 lines · Henning P. Schmiedehausen
Quoted 6 lines

Hi,

I know, that this is a FAQ and the Promise RAID controller card is not yet usable as a RAID board under Linux 2.x but is there a way to use the controller just like the UltraATA 100 controller?

It is not a raid board ... it is a raid lie

Quoted 3 lines

I know, that "input high == UltraATA core, input low = RAID core" according to Andre Hedrick but I really don't care about the RAID core. I want to use this controller to drive JBOD.

Wrong, if Promise will opensource the signatures then we map the software raid against that location and use Linux's soft-raid.

Quoted 12 lines

Can one do this? The disks need not to be interchangeable to other controllers. Just be accessible.

2.2 solutions preferred, 2.4 ok.

Regards
Henning

--
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH [email protected]

Quoted 8 lines

Am Schwabachgrund 22 Fon.: 09131 / 50654-0 [email protected]
D-91054 Buckenhof Fax.: 09131 / 50654-20
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Andre Hedrick
Linux ATA Development
ASL Kernel Development
-----------------------------------------------------------------------------

ASL, Inc.                                     Toll free: 1-877-ASL-3535
1757 Houret Court                             Fax: 1-408-941-2071
Milpitas, CA 95035                            Web: www.aslab.com

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Signature · 5 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen       -- Geschaeftsfuehrer
INTERMETA - Gesellschaft fuer Mehrwertdienste mbH     [email protected]

Am Schwabachgrund 22  Fon.: 09131 / 50654-0   [email protected]
D-91054 Buckenhof     Fax.: 09131 / 50654-20   
#4 lore raw
In reply to Andre Hedrick
Quoted 6 lines · Erik van Asselt

Hmmmmm i have the Promise raid source for 2.2 kernel modules so what do you mean by opensource signatures

i have it working for 2.2 kernels but i can't get it to work properly in 2.4 So if someone want to look at the source !!!
it can be found on www.promise.com

The promise controller is not a hardware raid board, it is a regular IDE controller with a bios overlay. Their marketing is deceiving and fraudulent.

Their software raid is less flexible then Linuxes, and it's performance is inferior. The only advantages of a promise 'raid' controller is cross-OS compatibility and a simplified booting process.

Promises Linux 'drivers' are proprietary and a violation of the GPL. Because their drivers are closed source, you can not debug any kernel with it loaded and you will not be compatible with future upgrades to your kernel without promises good will.

Because of these reasons, it would be advantageous for Linux to understand promises boot signature and allow Linuxes built in raid driver to be used on promises 'raid' disk. Allowing for the cross-os compatibility and easy booting but retaining the flexible, high performance and open source of the Linux code.

Unfortunately, promise is more concerned with living their lie then providing a high quality product to their customers and refuses to provide the tiny bit of needed information.