Skip to contentSkip to conversation

FIC AD11(AMD 761/VIA 686B) AGP port not supported [fixed]

DISCUSSION Joshua Corbin 2 participants 2 messages May 18, 2001

lore
Share & tools
lore
#0 lore raw

Ok, so appending agp_try_unsupported at boot gets the agp working (at least tolerably). The problem now appears to be with the DRI part of X/Radeon driver, because after adding the line:
Option "noaccel" "true"
to my XF86Config, all is well.

Without it all that shows up on the screen is a bunch of boxes, from which you are then forced to C-A-Backspace, and C-A-Del, since the terminal is screwed. So as long as I don't need 3D-accel, I'm once again Winblows free. Thank-you all for the attention :-)

Josh

Signature · 4 lines
Get your free email from www.linuxmail.org 


Powered by Outblaze
#1 lore raw
Quoted 10 lines · Joshua Corbin

Ok, so appending agp_try_unsupported at boot gets the agp working (at least tolerably). The problem now appears to be with the DRI part of X/Radeon driver, because after adding the line:
Option "noaccel" "true"
to my XF86Config, all is well.

Without it all that shows up on the screen is a bunch of boxes, from which you are then forced to C-A-Backspace, and C-A-Del, since the terminal is screwed. So as long as I don't need 3D-accel, I'm once again Winblows free. Thank-you all for the attention :-)

FWIW, I have similar problems with the Radeon 64 VIVO (retail) with my Abit KT7A. The DRI people are aware that it's broken but so far it works for some people and not others, and nobody is exactly sure what the problem is. Your best bet is to avoid accelleration for now.

Since you have an AMD chipset, it appears the problem is not limited to VIA. That's too bad, I was considering upgrading to an AMD board to get around this problem (and several others too..)

Signature · 3 lines
Joseph Carter <[email protected]>                Free software developer

Steal this tagline.  I did.