Skip to contentSkip to conversation

Hard lockup switching to X from vc; Matrox G400 AGP

DISCUSSION Chris Rankin 1 participant 1 message May 28, 2001 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hi, thanks for confirming this. But if it's Matrox's code (we are talking about the mga_hal_drv.o module for X, correct?) then the ball is in their court. Has anyone reported this to them so that they can fix it?

Cheers,
Chris

Quoted 17 lines · Ben Twijnstra
Quoted 6 lines

Hi Chris,

Seen the same behaviour; you're not alone. I'm running XF86 4.0.3 with a G400. My guess is that mga_drv goes into some local loop while trying to restore the display. mga_drv at that moment has I/O privileges and if it hangs, Linux hangs too.

It is problem with their driver. Their are resetting too much of hardware state during mode switches and if someone accesses memory at that moment, whole thing locks up your PCI bus - if you have ATX box, try hitting poweroff button next time it lockups. If poweroff does not work you'll have bad time to get it debugged. If poweroff button works, you can try kdb...

On my machine it is 100% reproducible if I run 'fbtv -k' and start X. It will die immediately.