2.4.8-ac6 ad1848 module failed at init
In kernel 2.4.8-ac6, with
# CONFIG_PNP is not set
# CONFIG_ISAPNP is not set
# CONFIG_PNPBIOS is not setCONFIG_SOUND=yCONFIG_SOUND_OSS=mCONFIG_SOUND_TRACEINIT=yCONFIG_SOUND_DMAP=yCONFIG_SOUND_TRIX=mCONFIG_SOUND_SB=mCONFIG_SOUND_YM3812=m
module ad1848 built but failed at init with "No device found."
I reverted, by copying ad1848.c from the -ac4 tree, and the resulting module loaded successfully, and seems to be functioning correctly.
Signature · 2 lines
| G r e g L o u i s | gpg public key: | | http://www.bgl.nu/~glouis | finger [email protected] |
Quoted 4 lines
module ad1848 built but failed at init with "No device found."
I reverted, by copying
ad1848.cfrom the -ac4 tree, and the resulting module loaded successfully, and seems to be functioning correctly.
Is your card plug and play ?
Quoted 6 lines · Alan Cox
Quoted 4 lines
module ad1848 built but failed at init with "No device found."
I reverted, by copying
ad1848.cfrom the -ac4 tree, and the resulting module loaded successfully, and seems to be functioning correctly.Is your card plug and play ?
No, the params are selected among a limited set of combinations with DIP switches. The trix module load instruction goes insmod trix io=0x530 irq=9 dma=3 dma2=0 sb_io=0x220 sb_dma=1 \
sb_irq=7 mpu_io=0x370 mpu_irq=5
Signature · 2 lines
| G r e g L o u i s | gpg public key: | | http://www.bgl.nu/~glouis | finger [email protected] |