Skip to contentSkip to conversation

Debugging Linux with PPCBoot and the BDI2000

DISCUSSION Boerner, Brian 3 participants 3 messages Aug 17, 2001

lore
Share & tools
lore
#0 lore raw

I'm trying to debug my kernel using PPCBoot to load the kernel image via tftpboot and then stop it in start_kernel.

I do the following.
1. Power up the to PPCBoot prompt
2. Load the vmlinux.img image via tftpboot created using the mkimage tool.
3. Load vmlinux into gdb that's connected to the bdi2000 at addr 0xc0000000
4. set a break at start_kernel (breaking on _start didn't work at all).
5. Telling PPCBoot to bootm
6. The debugger stops in start_kernel

Now, when I try to step or next I get the following error from gdb:
Breakpoint 2, start_kernel () at init/main.c:530
(gdb) display/i $pc
1: x/i $pc 0xc0142660 <start_kernel+16>: lis r9,-16364
(gdb) s
Cannot access memory at address 0x1100

I was under the impressions that the MMU has already been initilized at this point and we should be running with vaddrs, hence the 0xc0000000 start_kernel function. But, it appears that for some reason gdb is confused about v to p.

What am I doing wrong here?

Confused.
-bmb

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#1 lore raw

IBM PPC405 - when did the USB disappear?

I was looking through some stuff from late 1998.
At this point the 405 was believed to have an on-chip USB as well (405x3).

Does anybody know why it disappeared? Meaningless to say that I could use it now :-)

Sincerely,

Dr. Karsten Jeppesen
VP of Technology
Total Impact
<[email protected]>
----------------------------------------------------------------------
Lie, n.:
A very poor substitute for the truth, but the only one
discovered to date.
----------------------------------------------------------------------

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#2 lore raw
In reply to Boerner, Brian
Quoted 3 lines · Brian

I'm trying to debug my kernel using PPCBoot to load the kernel image via tftpboot and then stop it in start_kernel.

Ensure you are using the latest 2_4_devel kernel and Abatron firmware. We have been developing something that will work better for Linux, with less overhead and more flexibility on both sides. It was required due to 2.4.x page table changes, and I finally got the Linux part of it checked in.

Quoted 1 line

4. set a break at start_kernel (breaking on _start didn't work at all).

That's because _start isn't a virtual address as indicated in the vmlinux
symbol table. Set a hard breakpoint at zero if you must stop there.

	-- Dan

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/