Skip to contentSkip to conversation

Secure network fileserving Linux <-> Linux

OFFTOPIC Jesse Pollard 2 participants 2 messages Sep 6, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 29 lines · Jesse Pollard
Quoted 16 lines

Third answer:

A more reasonable way is to configure the user accessable systems as just X terminals (no MACs though) on a switched ethernet. Configure
the switch with a fixed MAC address for each target (prevents hardware
substitution). Now you can put the actual user work machines as compute servers in a different room. The compute servers (the ones users log into) can then use a physically isolated network (users can't plug things into it) for NFS to a file server.

This is still more extensive (and expensive) than a small lab is usually willing to accept.

Fourth answer:

Quoted 7 lines

The minimum would be to use a switched ethernet, with fixed MAC addressing. This prevents walk-in users from substituting equipement, and it limits the ability to sniff the network. Only packets destined for one IP would be visible, and the switch should be able to signal an alarm if it detects an unauthorized MAC address (as well as refuse to work). This still allows for NFS, and a higher throughput as well (each node can use the full bandwidth).

Both your Third and Fouth answer depend on MAC addresses locked down on the switch. This is fatally flawed since (as the orginal poster pointed out), changing your MAC address to match the expected MAC is quite easy.

Quoted 7 lines
# ifconfig eth0 ether A0:B1:C2:D3:E4:F4

How can you get the expected MAC address?

1. Walk up to an allowed computer, unplug computer from wall jack. Plug cross over cable from allowed computer into laptop. Sniff MAC address from frames generated by allowed computer.

or plug in a small hub and sniff valid traffic.

Quoted 5 lines

- Reconfigure your eth0 with allowed MAC, plug into network

2. Walk up to an allowed computer, unplug computer from wall jack. Plug into wall jack and sniff destination MAC address on frames sent by switch.

Quoted 7 lines

- Reconfigure your eth0 with allowed MAC

One solution is to require layer 2 authentication from the switch, before it fowards frames on that port. Before DHCP. This process could be repeated every time link is lost. The switch uses RADIUS off of some authentication server.

Good point. I didn't think of that one - my environment doesn't require it (physical security is good here).

Quoted 2 lines

The 802.11x standard(s) implement this for wireless networks, it can also be used on wired networks (the specs allow it at least).

I wouldn't want to use 802.11 for much of anything where security is important. It's just too easy to crack. You also need good physical and OS security to implement VPNs over wireless.

-------------------------------------------------------------------------
Jesse I Pollard, II
Email: [email protected]

Any opinions expressed are solely my own.

#1 lore raw
Quoted 6 lines · Jesse Pollard
Quoted 2 lines

The 802.11x standard(s) implement this for wireless networks, it can also be used on wired networks (the specs allow it at least).

I wouldn't want to use 802.11 for much of anything where security is important. It's just too easy to crack. You also need good physical and OS security to implement VPNs over wireless.

That would be 802.11 over a wired network, not wireless....