Toshiba IDE DMA support
I just received the documention for the IDE conrollers in may older Toshiba notebooks. These controllers are capable of DMA, but at the moment do not have it implemented. I know nothing about programming IDE drivers, so if anyone is interested in developing these drivers shoot me an email and I can send you the docs and help with testing (I have several notebooks to test on). I'd like to get into it myself, but just don't have the time.
Alex
__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
Quoted 3 lines
capable of DMA, but at the moment do not have it implemented. I know nothing about programming IDE drivers, so if anyone is interested in developing
If they follow the standard model you should actully have very little code to write.
Alan
I'll try and take a look at the code in the kernel this weekend if I get a chance, however, This is not a PCI IDE controller (at least it doesn't show up with lspci). I don't know if that makes a difference or not.
Alex
Quoted 9 lines · --- Alan Cox
Quoted 3 lines
capable of DMA, but at the moment do not have it implemented. I know nothing about programming IDE drivers, so if anyone is interested in developing
If they follow the standard model you should actully have very little
code to write.Alan
__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
Quoted 4 lines
this weekend if I get a chance, however, This is not a PCI IDE controller (at least it doesn't show up with lspci). I don't know if that makes a difference or not.
That might make it a bit harder, it depends on the general behaviour. If its bus mastering and follows the standard behaviour you have to provide the chipset setup and tuning - which is normally "load xyz registers with abc value for each mode"
Take a look at the serverworks driver
Quoted 10 lines
From Alex Deucher on Friday, 07 September, 2001:
I just received the documention for the IDE conrollers in may older Toshiba notebooks. These controllers are capable of DMA, but at the moment do not have it implemented. I know nothing about programming IDE drivers, so if anyone is interested in developing these drivers shoot me an email and I can send you the docs and help with testing (I have several notebooks to test on). I'd like to get into it myself, but just don't have the time.
Heh. "No time." Sounds familiar. :)
I don't have the knoff-hoff (know-how) either, but I'd like
to know what models you have info on. I'd be very interested in any documentation you might have on the Satellite 1605CDS. At the very least, I like to collect info so that it's available later on.
I have DMA enabled on my Satellite 1605CDS, but only via a hack.
If I enable ALi 15xx support in the kernel, I find that I can't suspend my laptop to disk (it hands off to BIOS well, but then BIOS freezes when it starts to save the "Extended" memory.) So, what I do is build an ALi-enabled kernel, then reboot to a non-ALi-enabled kernel. For some reason, it saves this DMA-enabled info between soft reboots. So, since it's Linux and I essentially never have to hard-reboot (or even give it the 3-finger salute) this works fairly well. It's only when it's actually been shut off or hard rebooted (via the switch) that DMA gets disabled again.
I'd like to fix the ALi support so I can suspend to disk, but I
don't know where to begin. I don't have the specs.
Where did you get this info? I'd be very curious what else we
can get out.
-Joseph
Signature · 5 lines
Joseph==============================================jap3003@ksu.edu "The message that 'resistance is futile' has been hammered home. The only OS projects that stand a chance [against Microsoft] are open source, because they don't play by the rules of the economy." http://www.byte.com/documents/s=1115/byt20010824s0001
Quoted 11 lines · Alex Deucher
I just received the documention for the IDE conrollers in may older Toshiba notebooks. These controllers are capable of DMA, but at the moment do not have it implemented. I know nothing about programming IDE drivers, so if anyone is interested in developing these drivers shoot me an email and I can send you the docs and help with testing (I have several notebooks to test on). I'd like to get into it myself, but just don't have the time.
Alex
Sure send the docs over!
Andre Hedrick
CTO ASL, Inc.
Linux ATA Development
-----------------------------------------------------------------------------
ASL, Inc. Tel: (510) 857-0055 x103 38875 Cherry Street Fax: (510) 857-0010 Newark, CA 94560 Web: www.aslab.com