Skip to contentSkip to conversation

linux-2.4.11-pre3-xfs oops in advansys driver

DISCUSSION [email protected] 1 participant 2 messages Oct 5, 2001

lore
Share & tools
lore
#0 lore raw

I am using linux-2.4.11-pre3-xfs from SGI XFS CVS on a debian woody. The machine is a K6-III/500 with 512 MB RAM. The system is installed on two disks attached to an advansys controller:
scsi0 : AdvanSys SCSI 3.3G: PCI Ultra-Wide: PCIMEM 0xE080A000-0xE080A03F, IRQ 0x5

    Vendor: IBM       Model: DCHS04W           Rev: 6464
    Type:   Direct-Access                      ANSI SCSI revision: 02
    Vendor: IBM       Model: DCHS04U           Rev: 6464
    Type:   Direct-Access                      ANSI SCSI revision: 02

lspci -v shows
00:09.0 SCSI storage controller: Advanced System Products, Inc ABP940-UW
Flags: bus master, medium devsel, latency 64, IRQ 5
I/O ports at d800 [size=64]
Memory at e9000000 (32-bit, non-prefetchable) [size=256] Expansion ROM at <unassigned> [disabled] [size=64K]

Last night, while my wife was browsing using Netscape, the machine looked up hard. This is what the serial console captured before oops:

invalidate: busy buffer
invalidate: busy buffer
invalidate: busy buffer
invalidate: busy buffer
advansys: adv_isr_callback: board 0: scp 0xdfef9600 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9400 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9200 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef8c00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef8400 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef8200 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef8000 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9e00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9c00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9a00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9800 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfefe000 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840e00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840c00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840a00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840800 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840600 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840400 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840200 not on active queue
advansys: adv_isr_callback: board 0: scp 0xc1840e00 not on active queue

And then this oops, decoded:

ksymoops 2.4.3 on i586 2.4.11-pre3-xfs. Options used
-V (default)
-k /proc/ksyms (default)
-l /proc/modules (default)
-o /lib/modules/2.4.11-pre3-xfs/ (default) -m /boot/System.map-2.4.11-pre3-xfs (default)

Warning: You did not tell me where to find symbol information. I will assume that the log matches the kernel and modules that are running right now and I'll use the default options above for symbol resolution. If the current kernel and/or modules do not match the log, you can get more accurate output by telling me the kernel version and where to find map, modules, ksyms etc. ksymoops -h explains the options.

c022c5ae
*pde = 00000000

Oops: 0002
CPU:    0
EIP:    0010:[<c022c5ae>]    Not tainted

Using defaults from ksymoops -t elf32-i386 -a i386
EFLAGS: 00013002
eax: c186adf0 ebx: c80004fe ecx: df126000 edx: f000ef57
esi: 880004fe edi: c0335084 ebp: 00003046 esp: de09df48
ds: 0018 es: 0018 ss: 0018
Process XFree86 (pid: 381, stackpage=de09d000)

Stack: c0335000 c033507c 00000000 c02248dc c0335084 c180ef40 24000001 00000005
       de09dfc4 00000000 00000000 db769ea0 00000000 c0107d6c 00000005 c033507c
       de09dfc4 000000a0 c03049a0 00000005 de09dfbc c0107ece 00000005 de09dfc4
Call Trace: [<c02248dc>] [<c0107d6c>] [<c0107ece>] [<c0109c68>]
Code: c6 83 18 00 00 c0 01 c6 83 19 00 00 c0 00 c6 83 1a 00 00 c0
Quoted 1 line
Quoted 1 line

EIP; c022c5ae <AdvISR+72/12c> <=====

Trace; c02248dc <advansys_interrupt+84/180>
Trace; c0107d6c <handle_IRQ_event+30/5c>
Trace; c0107ece <do_IRQ+6e/b0>
Trace; c0109c68 <call_do_IRQ+6/e>
Code; c022c5ae <AdvISR+72/12c>
00000000 <_EIP>:
Code; c022c5ae <AdvISR+72/12c> <=====
0: c6 83 18 00 00 c0 01 movb $0x1,0xc0000018(%ebx) <=====
Code; c022c5b4 <AdvISR+78/12c>
7: c6 83 19 00 00 c0 00 movb $0x0,0xc0000019(%ebx)
Code; c022c5bc <AdvISR+80/12c>
e: c6 83 1a 00 00 c0 00 movb $0x0,0xc000001a(%ebx)

<0>Kernel panic: Aiee, killing interrupt handler!

1 warning issued. Results may not be reliable.

Thank you,
florin

Signature · 3 lines
"If it's not broken, let's fix it till it is."

41A9 2BDE 8E11 F1C5 87A6  03EE 34B3 E075 3B90 DFE4
#1 lore raw

The oops happened again:

Before oops:

advansys: adv_isr_callback: board 0: scp 0xdfef0800 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef0a00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef0c00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9e00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9c00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef0600 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfef9a00 not on active queue
advansys: adv_isr_callback: board 0: scp 0xdfefe000 not on active queue

and decoded:

ksymoops 2.4.3 on i586 2.4.11-pre3-xfs. Options used
-V (default)
-k /proc/ksyms (default)
-l /proc/modules (default)
-o /lib/modules/2.4.11-pre3-xfs/ (default) -m /boot/System.map-2.4.11-pre3-xfs (default)

Warning: You did not tell me where to find symbol information. I will assume that the log matches the kernel and modules that are running right now and I'll use the default options above for symbol resolution. If the current kernel and/or modules do not match the log, you can get more accurate output by telling me the kernel version and where to find map, modules, ksyms etc. ksymoops -h explains the options.

Unable to handle kernel paging request at virtual address 88000516
c022c5ae
*pde = 00000000
Oops: 0002
CPU:    0
EIP:    0010:[<c022c5ae>]    Not tainted

Using defaults from ksymoops -t elf32-i386 -a i386
EFLAGS: 00210002
eax: c186ad50 ebx: c80004fe ecx: dc55e000 edx: f000ef57
esi: 880004fe edi: c0335084 ebp: 00200046 esp: c02d1f2c
ds: 0018 es: 0018 ss: 0018
Process swapper (pid: 0, stackpage=c02d1000)

Stack: c0335000 c033507c 00000000 c02248dc c0335084 c180ef40 24000001 00000005
       c02d1fa8 00000000 00000000 dfee9a20 00000000 c0107d6c 00000005 c033507c
       c02d1fa8 000000a0 c03049a0 00000005 c02d1fa0 c0107ece 00000005 c02d1fa8
Call Trace: [<c02248dc>] [<c0107d6c>] [<c0107ece>] [<c0105150>] [<c0109c68>]
   [<c0105150>] [<c0105173>] [<c01051d7>] [<c0105000>] [<c0105027>]
Code: c6 83 18 00 00 c0 01 c6 83 19 00 00 c0 00 c6 83 1a 00 00 c0
Quoted 1 line
Quoted 1 line

EIP; c022c5ae <AdvISR+72/12c> <=====

Trace; c02248dc <advansys_interrupt+84/180>
Trace; c0107d6c <handle_IRQ_event+30/5c>
Trace; c0107ece <do_IRQ+6e/b0>
Trace; c0105150 <default_idle+0/28>
Trace; c0109c68 <call_do_IRQ+6/e>
Trace; c0105150 <default_idle+0/28>
Trace; c0105172 <default_idle+22/28>
Trace; c01051d6 <cpu_idle+3e/54>
Trace; c0105000 <_stext+0/0>
Trace; c0105026 <rest_init+26/28>
Code; c022c5ae <AdvISR+72/12c>
00000000 <_EIP>:
Code; c022c5ae <AdvISR+72/12c> <=====
0: c6 83 18 00 00 c0 01 movb $0x1,0xc0000018(%ebx) <=====
Code; c022c5b4 <AdvISR+78/12c>
7: c6 83 19 00 00 c0 00 movb $0x0,0xc0000019(%ebx)
Code; c022c5bc <AdvISR+80/12c>
e: c6 83 1a 00 00 c0 00 movb $0x0,0xc000001a(%ebx)

<0>Kernel panic: Aiee, killing interrupt handler!

1 warning issued. Results may not be reliable.

florin

Signature · 3 lines
"If it's not broken, let's fix it till it is."

41A9 2BDE 8E11 F1C5 87A6  03EE 34B3 E075 3B90 DFE4