Skip to contentSkip to conversation

VM tests on 2.4.13-pre5aa1

DISCUSSION [email protected] 2 participants 2 messages Oct 19, 2001

lore
Share & tools
lore
#0 lore raw

Kernel: 2.4.13-pre5aa1

I discovered something important for the test results I've been reporting. The mp3's that I've been listening to were not all sampled at the same rate. That means some of the comparisons are suspect.

The mp3's were sampled between 88k and 192k. I did not notice the sample rate affecting whether an mp3 skips or not. I.E. an 88k mp3 and a 192k mp3 skip about the same on a kernel/test that sputters. There probably is a difference, but it isn't obvious. So the subjective reports on sound quality are reasonable. In the future, I'll make sure comparisons that include timing are done with comparable mp3's.

Timing variance:

mmap01  Low time: 4:13  High  4:29
mtest01	Low time:  :43  High  1:10

I'm not saying the difference between the high and low times is the variance between an 88k and 192k mp3. For mtest01 it could be, because that test is short enough to run a couple times during one song. mmap01 may have had part at 88k and part at 192k.

Okay, with the disclaimers out of the way. Here are the results:

mmap001

Average for 5 mmap001 runs

bytes allocated:                    2048000000
User time (seconds):                19.172
System time (seconds):              15.182
Elapsed (wall clock seconds) time:  258.82
Percent of CPU this job got:        12.80
Major (requiring I/O) page faults:  500169.0
Minor (reclaiming a frame) faults:  32.0

mtest01

Averages for 10 mtest01 runs

bytes allocated:                    1251370598
User time (seconds):                2.079
System time (seconds):              2.849
Elapsed (wall clock) time:          54.075
Percent of CPU this job got:        8.70

Major (requiring I/O) page faults: 107.2
Minor (reclaiming a frame) faults: 306293.2

Even though I made the disclaimers, I will note that 2.4.13-pre3aa1 was doing the mmap001 test consistently (4 runs) at around 210 seconds average. 2.4.13-pre5 and 2.4.13-pre5aa1 are both around 260 seconds.

Sound quality:

Mostly good for mtest01. page-cluster is 3.

Not as good, for mmap01. I'll give a subjective 4 on a scale of 10.

Ideally I'd have a nice long mp3, and could say the test took 18:27 and mp3 played 15:10 (or whatever).

One other note for people who do similar tests. mp3blaster skips less when compiled with glibc-linuxthreads-2.2.4 (default configure) than with pth-1.40. glibc-linuxthreads uses more memory and creates more processes though. All of my tests were with a glibc threads mp3blaster.

I'm looking forward to playing with Andrea's new knobs in /proc/sys/vm.

Have fun!

Signature · 1 line
Randy Hron
#1 lore raw

Interesting!
on the week end I will set up a stress test for the VM to see if I am able to get some failure. Just I need a little of time, since I am at SMAU for the magazine I write for (by the way, inside of the press room there is a very very pretty bar girl :) ).
mmm, I should immagine some good test case...

Luigi

Quoted 87 lines · On Fri, 19 Oct 2001 [email protected] wrote:

Kernel: 2.4.13-pre5aa1

I discovered something important for the test results I've been reporting. The mp3's that I've been listening to were not all sampled at the same rate. That means some of the comparisons are suspect.

The mp3's were sampled between 88k and 192k. I did not notice the sample rate affecting whether an mp3 skips or not. I.E. an 88k mp3 and a 192k mp3 skip about the same on a kernel/test that sputters. There probably is a difference, but it isn't obvious. So the subjective reports on sound quality are reasonable. In the future, I'll make sure comparisons that include timing are done with comparable mp3's.

Timing variance:

mmap01  Low time: 4:13  High  4:29
mtest01	Low time:  :43  High  1:10

I'm not saying the difference between the high and low times is the variance between an 88k and 192k mp3. For mtest01 it could be, because that test is short enough to run a couple times during one song. mmap01 may have had part at 88k and part at 192k.

Okay, with the disclaimers out of the way. Here are the results:

mmap001

Average for 5 mmap001 runs

bytes allocated:                    2048000000
User time (seconds):                19.172
System time (seconds):              15.182
Elapsed (wall clock seconds) time:  258.82
Percent of CPU this job got:        12.80
Major (requiring I/O) page faults:  500169.0
Minor (reclaiming a frame) faults:  32.0

mtest01

Averages for 10 mtest01 runs

bytes allocated:                    1251370598
User time (seconds):                2.079
System time (seconds):              2.849
Elapsed (wall clock) time:          54.075
Percent of CPU this job got:        8.70

Major (requiring I/O) page faults: 107.2
Minor (reclaiming a frame) faults: 306293.2

Even though I made the disclaimers, I will note that 2.4.13-pre3aa1 was doing the mmap001 test consistently (4 runs) at around 210 seconds average. 2.4.13-pre5 and 2.4.13-pre5aa1 are both around 260 seconds.

Sound quality:

Mostly good for mtest01. page-cluster is 3.

Not as good, for mmap01. I'll give a subjective 4 on a scale of 10.

Ideally I'd have a nice long mp3, and could say the test took 18:27 and mp3 played 15:10 (or whatever).

One other note for people who do similar tests. mp3blaster skips less when compiled with glibc-linuxthreads-2.2.4 (default configure) than with pth-1.40. glibc-linuxthreads uses more memory and creates more processes though. All of my tests were with a glibc threads mp3blaster.

I'm looking forward to playing with Andrea's new knobs in /proc/sys/vm.

Have fun!
--
Randy Hron

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/