Skip to contentSkip to conversation

2.4.16: hda9: attempt to access beyond end of device

DISCUSSION M G Berberich 4 participants 5 messages Nov 29, 2001 – Nov 30, 2001

lore
Share & tools
lore
#0 lore raw

Hello,

Partition boundary problem in 2.4.16 ?!

I just tried to make a mke2fs on my /dev/hda9 and mke2fs with kernel 2.4.16 and it failed with a partial write. /var/log/messages says:

kernel: 03:09: rw=0, want=289140, limit=289138
kernel: attempt to access beyond end of device

It works fine with 2.4.13 and it works with 2.4.16 if blocksize ist set to 4k (fails with 1k blocks). Both kernel have reiserfs- and ext3-support enabled and i2c- and lm_sensors-patches applied. mke2fs is version 1.25 (20-Sep-2001), using EXT2FS Library 1.25. Partition table is (fdisk -l /dev/hda):

Disk /dev/hda: 255 heads, 63 sectors, 5005 cylinders Units = cylinders of 16065 * 512 bytes

     Device Boot    Start       End    Blocks   Id  System
  /dev/hda1   *         1        24    192748+  83  Linux
  /dev/hda2            25        48    192780   83  Linux
  /dev/hda3            49        72    192780   83  Linux
  /dev/hda4            73      1432  10924200    5  Extended
  /dev/hda5            73        96    192748+  82  Linux swap
  /dev/hda6            97       120    192748+  83  Linux
  /dev/hda7           121       181    489951   83  Linux
  /dev/hda8           182       667   3903763+  83  Linux
  /dev/hda9           668       703    289138+  83  Linux
  /dev/hda10          704       946   1951866   83  Linux
  /dev/hda11          947      1432   3903763+  83  Linux

Linux avaloon 2.4.16 SMP i686 unknown

Gnu C                  2.95.2	    Gnu make               3.79.1
binutils               2.9.5.0.37   util-linux             2.11m
mount                  2.11m	    modutils               2.3.16
e2fsprogs              1.25	    Linux C Library        2.1.3

ldd: version 1.9.11 Procps 2.0.6
Net-tools 1.54 Console-tools 0.2.3
Sh-utils 2.0

I'm not on linux-kernel mailinglist, so please mail me If you need aditional information.

MfG
bmg

Signature · 3 lines
"Des is völlig wurscht, was heut beschlos- | M G Berberich
 sen wird: I bin sowieso dagegn!"          | [email protected]
(SPD-Stadtrat Kurt Schindler; Regensburg)  |
#1 lore raw
Quoted 3 lines · M G Berberich

Partition boundary problem in 2.4.16 ?!
I just tried to make a mke2fs on my /dev/hda9 and mke2fs with kernel 2.4.16 and it failed with a partial write. /var/log/messages says:

I have a similar problem with /dev/sda9. Booting 2.4.11...16 results in a partition not found error (as reported by fsck). Going back to 2.4.10ac10, fdisk tells me that the partition ID for sda9 is 0x0000 which is corrupt, and will be fixed on a write. I do the write, and sda9 is still invisible.

Delete and recreate the partition with the exact same cylinder values, and the partition comes back, but is unmountable and un-fsck-able.

Examining raw hex data from other partitions, I find that the ext2 label string (as set with the -L flag to mke2fs) occurs at offset 02160 (octal) into the raw partition. But on /dev/sda9, it is occurring at 01160 instead - off by one 512 byte sector. Foo. 2.4.16 has not made my day.

Kris

#2 lore raw
Quoted 4 lines · M G Berberich
Quoted 3 lines

Partition boundary problem in 2.4.16 ?!
I just tried to make a mke2fs on my /dev/hda9 and mke2fs with kernel 2.4.16 and it failed with a partial write. /var/log/messages says:

i recently got some of these messages about "attempt to access beyond end of device" when running badblocks on a partition, on 2.4.15-pre1. i got two of them, and in the end badblocks said it found 2 bad blocks. partitions were made with fdisk.
i don't know if it's normal or not, but bothers a little still. mke2fs went through without errors and haven't noticed any corruption so far.

janne.

#3 lore raw
In reply to M G Berberich

Hello,

Am Thursday, den 29. November 2001 22:58:14 schrieb berberic:

Quoted 10 lines

Partition boundary problem in 2.4.16 ?!

I just tried to make a mke2fs on my /dev/hda9 and mke2fs with kernel 2.4.16 and it failed with a partial write. /var/log/messages says:

kernel: 03:09: rw=0, want=289140, limit=289138
kernel: attempt to access beyond end of device

It works fine with 2.4.13 and it works with 2.4.16 if blocksize is set to 4k (fails with 1k blocks).

Now it failed with kernel 2.4.13 and mke2fs 1.25 on another partition, but works with kernel 2.4.13 and mke2fs 1.18. 1k-blocks again.

I'm now longer sure if it is the kernel or mke2fs or both:(

MfG
bmg

Signature · 3 lines
"Des is völlig wurscht, was heut beschlos- | M G Berberich
 sen wird: I bin sowieso dagegn!"          | [email protected]
(SPD-Stadtrat Kurt Schindler; Regensburg)  |
#4 lore raw
In reply to M G Berberich
Quoted 6 lines · M G Berberich

Am Thursday, den 29. November 2001 22:58:14 schrieb berberic:

Quoted 5 lines

Partition boundary problem in 2.4.16 ?!

I just tried to make a mke2fs on my /dev/hda9 and mke2fs with kernel 2.4.16 and it failed with a partial write. /var/log/messages says:

Quoted 8 lines
Quoted 5 lines

kernel: 03:09: rw=0, want=289140, limit=289138
kernel: attempt to access beyond end of device

It works fine with 2.4.13 and it works with 2.4.16 if blocksize is set to 4k (fails with 1k blocks).

Now it failed with kernel 2.4.13 and mke2fs 1.25 on another partition, but works with kernel 2.4.13 and mke2fs 1.18. 1k-blocks again.

To avoid issues with mke2fs, try "dd if=/dev/hda9 of=/dev/null bs=X" where X=512,1k,2k,4k under both kernels and see if it still gives errors. Also, mke2fs outputs the device size that it got via the BLKGETSIZE ioctl, so that may be informative also. If you do an strace of mke2fs, you should see that it is calling BLKGETSIZE (about 70 lines in, on my system). If that ioctl is failing, then it may be a bug elsewhere in the mke2fs code (which is rarely used), although it is unlikely.

The likely reason it is failing with 1kB blocks and not 4kB blocks is that mke2fs will ignore up to 3kB at the end of the device if it is not a full multiple of the block size (i.e. 4kB).

Cheers, Andreas
--
Andreas Dilger
http://sourceforge.net/projects/ext2resize/
http://www-mddsp.enel.ucalgary.ca/People/adilger/