Skip to contentSkip to conversation

Tian Tiger MP (AMD760MP chipset) and UDMA ATA 66/100

DISCUSSION German Gomez Garcia 2 participants 2 messages Dec 11, 2001

lore
Share & tools
lore
#0 lore raw

Hello,

I have a Tian Tiger MP (http://www.tyan.com/products/html/tigermp.html)
that is supposed to support ATA100 harddrives, I currently have 3 UWSCSI 9Gb hard drives in raid0 with the main system, and I'm thinking of buying two or three big (60+Gb) ATA100 drives for video capturing and editing, I would like to know what is the current status (in the 2.4.x series) of the UDMA driver for the AMD760MP chipset. Any experience with this configuration? I currently have old 40Gb 5400rpm hard drives on old cables, so no way to test it before buying.

Regards,

- german

PS: Please CC to me as I'm not subscribed to the LIST :-).
-------------------------------------------------------------------------
German Gomez Garcia | Send email with "SEND GPG KEY" as subject
<[email protected]> | to receive my GnuPG public key.

#1 lore raw
Quoted 2 lines · you

I would like to know what is the current status (in the 2.4.x series) of the UDMA driver for the AMD760MP chipset.

One of the machines I am involved with has the Tyan Tiger MP 1.03 motherboard. It has a Maxtor 6L080J4 as the ide0 master, /dev/hda.

The stock 2.4.16 amd74xx driver defaults to UDMA2 on /dev/hda, and with that configuration I get an hdparm -T of 21.40 MB/sec. The ide0=ata66 kernel option successfully forces the drive and interface to UDMA4, giving an hdparm -T of 38.1 MB/sec. I seem to recall that without ide0=ata66, I was limited to UDMA2 (with hdparm -X), but I can't verify that at this time.

The relevant boot messages from stock 2.4.16 with the ide0=ata66 kernel option are below. Note the message "hda: setting to mode 4, driver problems in mode 5." That must be why I get UDMA4 instead of UDMA5 in this configuration. But UDMA4 is plenty, I think; I have not tried "hdparm -X69 /dev/hda".

I actually am usually running with Andre Hedrick's ATA patch (the 2001-11-24 version, I'm about to try the 2001-12-10 version). This is because I have two PDC20268 cards (Promise Ultra100TX2), and the stock kernel gives the "ERROR, PORT ADDRESSES ALREADY IN USE" messages below for the second card. Then I can only do MDMA2 on the first PDC20268 and PIO on the second PDC20268. Ander Hedrick's ATA patch gives me UDMA5 on all the interfaces.

Cheers,
Wayne

Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
AMD7411: IDE controller on PCI bus 00 dev 39
AMD7411: chipset revision 1
AMD7411: not 100%% native mode: will probe irqs later
AMD7411: disabling single-word DMA support (revision < C4)
AMD7411: ATA-66/100 forced bit set (WARNING)!!

    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio

PDC20268: IDE controller on PCI bus 00 dev 48
PDC20268: chipset revision 1
PDC20268: not 100%% native mode: will probe irqs later
PDC20268: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary MASTER Mode.

    ide2: BM-DMA at 0x1410-0x1417, BIOS settings: hde:pio, hdf:pio
    ide3: BM-DMA at 0x1418-0x141f, BIOS settings: hdg:pio, hdh:pio

PDC20268: IDE controller on PCI bus 00 dev 50
PDC20268: chipset revision 1
PDC20268: not 100%% native mode: will probe irqs later
PDC20268: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.

    ide4: BM-DMA at 0x1420-0x1427 -- ERROR, PORT ADDRESSES ALREADY IN USE
    ide5: BM-DMA at 0x1428-0x142f -- ERROR, PORT ADDRESSES ALREADY IN USE

hda: MAXTOR 6L080J4, ATA DISK drive
hdc: OnStream ADR Series, ATAPI TAPE drive
hde: MAXTOR 6L080J4, ATA DISK drive
hdg: HL-DT-ST RW/DVD GCC-4120B, ATAPI CD/DVD-ROM drive
hdi: MAXTOR 6L080J4, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0x1448-0x144f,0x1442 on irq 10
ide3 at 0x1438-0x143f,0x1436 on irq 10
ide4 at 0x1460-0x1467,0x145a on irq 5
hda: setting to mode 4, driver problems in mode 5.
hda: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, UDMA(66)
hde: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63, (U)DMA
hdi: 156355584 sectors (80054 MB) w/1819KiB Cache, CHS=155114/16/63