Skip to contentSkip to conversation

2.5.1-dj1

DISCUSSION Dave Jones 2 participants 3 messages Dec 17, 2001

lore
Share & tools
lore

Dave Jones

author
#0 lore raw

Judging by the interest the last patch (which wasn't announced so publically) got, and the supportive emails I recieved, I figure there's enough interest for me to keep this up at least until Linus is ready to resync. (plus, Linus seems interested in me keeping this stuff in a ready-to-merge
state, which is good enough reason as any. 8)

Patch is available from:
http://www.codemonkey.org.uk/patches/2.5/patch-2.5.1-dj1.diff.bz2

On with the changelog..

This syncs up 2.5 right up to 2.4.17rc1.
Merge a few of the more trivial "2.5 material" salvaged from the last -ac tree, a few fixes from the kernel list, and a few other pending bits.. Some of these fixes haven't found their way back to Marcelo yet, but should show up in 2.4.17-rc2 / 2.4.18pre1 with any luck.

2.5.1-dj1

o   Resync with 2.5.1
    | drop reiserfs changes. 2.4's look to be more complete.
o   Fix potential sysvfs oops.				(Christoph Hellwig)
o   Loopback driver deadlock fix.			(Andrea Arcangeli)
o   __devexit cleanups in drivers/net/			(Daniel Chen,
    synclink, wdt_pci & via82cxxx_audio 		 John Tapsell)
o   Configure.help updates				(Eric S. Raymond)
o   Make reiserfs compile again.				(Me)
o   bio changes for ide floppy					(Me)
    | handle with care, compiles, but is unfinished.
o   Make x86 identify_cpu() happen earlier			(Me)
    | PPro errata workaround & APIC setup got a little
    | cleaner as a result.
o   Blink keyboard LEDs on panic				(From 2.4.13-ac)
o   Change current->state frobbing to set_current_state()	(From 2.4.13-ac)
o   Add MODULE_LICENSE tags for acpi,md.c,fmvj18x,		(From 2.4.13-ac)

atyfb & fbmem.

2.5.1pre11-dj2

o   Merge with 2.4.17rc1
o   Activate out of order stores on IDT Winchips.		(From 2.4.13-ac)
o   ICH2 APIC support						(From 2.4.13-ac)
o   Activate Simple boot flag support				(From 2.4.13-ac)
    | was merged in -dj1, but not mentioned.
o   Remove matroxfb PLL debugging message.			(Me)

2.5.1pre11-dj1
o Merge with 2.4.17pre8
Drop devfs changes. (Newer version in 2.5)
o Make ncr53c8xx bio aware. (Me)

Signature · 2 lines
| Dave Jones.                    http://www.codemonkey.org.uk
| SuSE Labs .
#1 lore raw
Quoted 2 lines · Dave Jones

o bio changes for ide floppy (Me)
| handle with care, compiles, but is unfinished.

This is still badly broken -- I've attached my version I did for somebody friday.

drivers/ide/ide-floppy.c renamed from opt/kernel/linux-2.5.1/drivers/ide/ide-floppy.c +24 -43
@@ -336,23 +336,7 @@
 #define	IDEFLOPPY_IOCTL_FORMAT_START		0x4602
 #define IDEFLOPPY_IOCTL_FORMAT_GET_PROGRESS	0x4603
 
-/*
- *	Special requests for our block device strategy routine.
- */
-#define	IDEFLOPPY_FIRST_RQ		90
-
-/*
- * 	IDEFLOPPY_PC_RQ is used to queue a packet command in the request queue.
- */
-#define	IDEFLOPPY_PC_RQ			90
-
-#define IDEFLOPPY_LAST_RQ		90
-
-/*
- *	A macro which can be used to check if a given request command
- *	originated in the driver or in the buffer cache layer.
- */
-#define IDEFLOPPY_RQ_CMD(cmd) 		((cmd >= IDEFLOPPY_FIRST_RQ) && (cmd <= IDEFLOPPY_LAST_RQ))
+#define IDEFLOPPY_RQ			(REQ_SPECIAL)
 
 /*
  *	Error codes which are returned in rq->errors to the higher part
@@ -696,7 +680,7 @@
 	/* Why does this happen? */
 	if (!rq)
 		return;
-	if (!IDEFLOPPY_RQ_CMD (rq->cmd)) {
+	if (rq->flags & IDEFLOPPY_RQ) {
 		ide_end_request (uptodate, hwgroup);
 		return;
 	}
@@ -776,7 +760,7 @@
 {
 	ide_init_drive_cmd (rq);
 	rq->buffer = (char *) pc;
-	rq->cmd = IDEFLOPPY_PC_RQ;
+	rq->flags = IDEFLOPPY_RQ;
 	(void) ide_do_drive_cmd (drive, rq, ide_preempt);
 }
 
@@ -1192,6 +1176,7 @@
 {
 	int block = sector / floppy->bs_factor;
 	int blocks = rq->nr_sectors / floppy->bs_factor;
+	int cmd = rq_data_dir(rq);
 	
 #if IDEFLOPPY_DEBUG_LOG
 	printk ("create_rw1%d_cmd: block == %d, blocks == %d\n",
@@ -1200,18 +1185,18 @@
 
 	idefloppy_init_pc (pc);
 	if (test_bit (IDEFLOPPY_USE_READ12, &floppy->flags)) {
-		pc->c[0] = rq->cmd == READ ? IDEFLOPPY_READ12_CMD : IDEFLOPPY_WRITE12_CMD;
+		pc->c[0] = cmd == READ ? IDEFLOPPY_READ12_CMD : IDEFLOPPY_WRITE12_CMD;
 		put_unaligned (htonl (blocks), (unsigned int *) &pc->c[6]);
 	} else {
-		pc->c[0] = rq->cmd == READ ? IDEFLOPPY_READ10_CMD : IDEFLOPPY_WRITE10_CMD;
+		pc->c[0] = cmd == READ ? IDEFLOPPY_READ10_CMD : IDEFLOPPY_WRITE10_CMD;
 		put_unaligned (htons (blocks), (unsigned short *) &pc->c[7]);
 	}
 	put_unaligned (htonl (block), (unsigned int *) &pc->c[2]);
 	pc->callback = &idefloppy_rw_callback;
 	pc->rq = rq;
 	pc->b_data = rq->buffer;
-	pc->b_count = rq->cmd == READ ? 0 : rq->bio->bi_size;
-	if (rq->cmd == WRITE)
+	pc->b_count = cmd == READ ? 0 : rq->bio->bi_size;
+	if (rq->flags & REQ_RW)
 		set_bit (PC_WRITING, &pc->flags);
 	pc->buffer = NULL;
 	pc->request_transfer = pc->buffer_size = blocks * floppy->block_size;
@@ -1227,8 +1212,8 @@
 	idefloppy_pc_t *pc;
 
 #if IDEFLOPPY_DEBUG_LOG
-	printk (KERN_INFO "rq_status: %d, rq_dev: %u, cmd: %d, errors: %d\n",rq->rq_status,(unsigned int) rq->rq_dev,rq->cmd,rq->errors);
-	printk (KERN_INFO "sector: %ld, nr_sectors: %ld, current_nr_sectors: %ld\n",rq->sector,rq->nr_sectors,rq->current_nr_sectors);
+	printk (KERN_INFO "rq_status: %d, rq_dev: %u, flags: %lx, errors: %d\n",rq->rq_status,(unsigned int) rq->rq_dev,rq->flags,rq->errors);
+	printk (KERN_INFO "sector: %ld, nr_sectors: %ld, current_nr_sectors: %d\n",rq->sector,rq->nr_sectors,rq->current_nr_sectors);
 #endif /* IDEFLOPPY_DEBUG_LOG */
 
 	if (rq->errors >= ERROR_MAX) {
@@ -1240,24 +1225,20 @@
 		idefloppy_end_request (0, HWGROUP(drive));
 		return ide_stopped;
 	}
-	switch (rq->cmd) {
-		case READ:
-		case WRITE:
-			if (rq->sector % floppy->bs_factor || rq->nr_sectors % floppy->bs_factor) {
-				printk ("%s: unsupported r/w request size\n", drive->name);
-				idefloppy_end_request (0, HWGROUP(drive));
-				return ide_stopped;
-			}
-			pc = idefloppy_next_pc_storage (drive);
-			idefloppy_create_rw_cmd (floppy, pc, rq, block);
-			break;
-		case IDEFLOPPY_PC_RQ:
-			pc = (idefloppy_pc_t *) rq->buffer;
-			break;
-		default:
-			printk (KERN_ERR "ide-floppy: unsupported command %x in request queue\n", rq->cmd);
-			idefloppy_end_request (0,HWGROUP (drive));
+	if (rq->flags & REQ_CMD) {
+		if (rq->sector % floppy->bs_factor || rq->nr_sectors % floppy->bs_factor) {
+			printk ("%s: unsupported r/w request size\n", drive->name);
+			idefloppy_end_request (0, HWGROUP(drive));
 			return ide_stopped;
+		}
+		pc = idefloppy_next_pc_storage (drive);
+		idefloppy_create_rw_cmd (floppy, pc, rq, block);
+	} else if (rq->flags & IDEFLOPPY_RQ) {
+		pc = (idefloppy_pc_t *) rq->buffer;
+	} else {
+		blk_dump_rq_flags(rq, "ide-floppy: unsupported command in queue");
+		idefloppy_end_request (0,HWGROUP (drive));
+		return ide_stopped;
 	}
 	pc->rq = rq;
 	return idefloppy_issue_pc (drive, pc);
@@ -1273,7 +1254,7 @@
 
 	ide_init_drive_cmd (&rq);
 	rq.buffer = (char *) pc;
-	rq.cmd = IDEFLOPPY_PC_RQ;
+	rq.flags = IDEFLOPPY_RQ;
 	return ide_do_drive_cmd (drive, &rq, ide_wait);
 }
 
Signature · 1 line
Jens Axboe
author
#2 lore raw
Quoted 6 lines · Jens Axboe
Quoted 2 lines · Dave Jones

o bio changes for ide floppy (Me)
| handle with care, compiles, but is unfinished.

This is still badly broken -- I've attached my version I did for somebody friday.

Yeah, I got distracted halfway through, and never got around to it. I'll drop this into the -dj2, thanks.

Dave.

Signature · 2 lines
| Dave Jones.        http://www.codemonkey.org.uk
| SuSE Labs