Skip to contentSkip to conversation

how to map network cards ?

DISCUSSION Jesse Pollard 2 participants 2 messages Dec 31, 2001

lore
Share & tools
lore
#0 lore raw

--------- Received message begins Here ---------

Quoted 13 lines
Quoted 2 lines · Jesse Pollard

The only way to determine
the ACTUAL eth0 is via mac number and trial and error.

not correct, as noted in other e-mail.

Quoted 6 lines

I configure ONE interface (all others are down), then plug in to a working network.

If I can ping the other machine then I know which network a given interface is on - label it.

Quoted 8 lines
Quoted 2 lines

Now down that interface, and initialize another one. Repeat until all interfaces are identified.

also note that one can rename interfaces, or in the future they might appear out-of-order. To only way to be obsolutely certain where a network device is on the PCI bus is ETHTOOL_GDRVINFO.

Jeff

Does ETHTOOL_GDRVINFO work on ISA devices too? Last I knew it didn't. And I do run a system with both PCI and ISA network cards.

-------------------------------------------------------------------------
Jesse I Pollard, II
Email: [email protected]

Any opinions expressed are solely my own.

#1 lore raw
Quoted 19 lines · Jesse Pollard

--------- Received message begins Here ---------

Quoted 16 lines
Quoted 2 lines · Jesse Pollard

The only way to determine
the ACTUAL eth0 is via mac number and trial and error.

not correct, as noted in other e-mail.

Quoted 8 lines

I configure ONE interface (all others are down), then plug in to a working network.

If I can ping the other machine then I know which network a given interface is on - label it.

Now down that interface, and initialize another one. Repeat until all interfaces are identified.

Quoted 8 lines
Quoted 5 lines

also note that one can rename interfaces, or in the future they might appear out-of-order. To only way to be obsolutely certain where a network device is on the PCI bus is ETHTOOL_GDRVINFO.

Jeff

Does ETHTOOL_GDRVINFO work on ISA devices too? Last I knew it didn't. And I do run a system with both PCI and ISA network cards.

The interface works fine with ISA, but it might not be implemented in one particular driver or another. 2.4.18-pre1 supports some but not all ISA drivers.

Jeff

Signature · 3 lines
Jeff Garzik      | Only so many songs can be sung
Building 1024    | with two lips, two lungs, and one tongue.
MandrakeSoft     |         - nomeansno