3ware: SCSI device sda: 1562951681 512-byte hdwr sectors (-299279 MB)
Hi!
Not sure if this is a 3ware driver 'bug'. This is a 3ware 7810 with 8 100GB disks, configured hw raid0.
part of dmesg:
SCSI subsystem driver Revision: 1.00
3ware Storage Controller device driver for Linux v1.02.00.010. scsi0 : Found a 3ware Storage Controller at 0x1090, IRQ: 5, P-chip: 1.3 scsi0 : 3ware Storage Controller
Vendor: 3ware Model: 3w-xxxx Rev: 1.0
Type: Direct-Access ANSI SCSI revision: 00
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 1562951681 512-byte hdwr sectors (-299279 MB)
sda: unknown partition table
It should say something like 800GB, but says -299279 MB.
This is with the xfs 2.4.17 kernel. The raid works fine, it seemes just cosmetic, but thought I'd better report it anyway.
Ookhoi
You need revision XX.15 > of the 3ware driver to handle 48 bit LBA. I am running at present with 160GB drives on the 7810 and no problem. There's also a firmware upgrade required of the card to get 48 bit LBA to work properly. www.3ware.com has the latest firmware.
Jeff
Quoted 29 lines · Ookhoi
Hi!
Not sure if this is a 3ware driver 'bug'. This is a 3ware 7810 with 8 100GB disks, configured hw raid0.
part of dmesg:
SCSI subsystem driver Revision: 1.00
3ware Storage Controller device driver for Linux v1.02.00.010. scsi0 : Found a 3ware Storage Controller at0x1090, IRQ: 5, P-chip: 1.3 scsi0 : 3ware Storage Controller
Vendor: 3ware Model: 3w-xxxx Rev: 1.0
Type: Direct-Access ANSI SCSI revision: 00
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 1562951681 512-byte hdwr sectors (-299279 MB)
sda: unknown partition tableIt should say something like 800GB, but says -299279 MB.
This is with the xfs 2.4.17 kernel. The raid works fine, it seemes just cosmetic, but thought I'd better report it anyway.
Ookhoi
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/