Skip to contentSkip to conversation

Trouble rebooting Tyan Thunder K7 (S2462UNG)

DISCUSSION Jan-Benedict Glaw 1 participant 1 message Apr 22, 2002 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

On Mon, 2002-04-22 09:23:11 -0400, Nicholas Berry <[email protected]> wrote in message <[email protected]>:

Quoted 3 lines

I've had the original problem with a Tyan Tiger MP board. Linux can't reboot it, Windoze 2000 can, but in my case the font is screwed up. I agree with Steve, it's a BIOS problem - the BIOS on my board is a POS.

Here are my 2 cent:

- The BIOS screws up (at least) ATI Radeon cards (their fonts)
- The newest versions (at least 2.09 and 2.10) require to press F1 if you use non-MP Athlons
- The newest BIOS version (2.10) does __not__ mention a second CPU in the MP table if you use non-MP Athlons. This means that basically the board unconditionally boots up with only __one__ CPU, even if you press F1 to accept a non-supported mode.
- I've added an additional SCSI card. The box didn't come up because this additional card was bootable. I had to remove the boot ROM of that card.

My conclusions:

- Basically, the board is *very* nice. Two Athlons, two U/160 SCSI channels, lots of ECC-protected RAM.
- BIOS is quite bad. It feels like being unready and is quite unfriendly to not officially supported (non-MP) dual Athlons. Despite that, there are problems with lots of other hardware (ATI Radeon cards, additional bootable SCSI cards, ...).

MfG, JBG

Signature · 3 lines
Jan-Benedict Glaw   .   [email protected]   .   +49-172-7608481
	 -- New APT-Proxy written in shell script --
	   http://lug-owl.de/~jbglaw/software/ap2/