Using 2_4_devel to build a kernel for the 8240
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hello;
I am using the latest bitkeeper PPC 2_4_devel kernel, and want to configure it for the 8240.
When I run menuconfig, I can see "Sandpoint X3" and "8260" selections, but no 8240 specific selections.
What options should I select to enable 8240 support? I am guessing "Sandpoint X3", is this right? The board is a custom 8240, with Ethernet and SCSI PCI chipsets, but no serial or ISA components. We have previously gotten a 2.3.16 kernel to work on it.
Thanks for any feedback.
Stephen Noftall
LCS
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 10 lines · Stephen Noftall
Hello;
I am using the latest bitkeeper PPC 2_4_devel kernel, and want to configure it for the 8240.
When I run menuconfig, I can see "Sandpoint X3" and "8260" selections, but no 8240 specific selections.
What options should I select to enable 8240 support? I am guessing "Sandpoint X3", is this right?
No. "Sandpoint" is a platform, not a processor. You select the processor from inside "Platform support"/"Processor Type". Since the 8240 is essentially a 603 core with a 107 bridge, select "6xx/7xx/74xx/8260" for your processory type.
You probably want to make a new "Machine Type" for your board/platform and select it. Look in arch/ppc/platforms and arch/ppc/config.in for lots of examples.
Mark
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 6 lines · Stephen Noftall
Hello;
I am using the latest bitkeeper PPC 2_4_devel kernel, and want to configure it for the 8240.
Quoted 7 lines
When I run menuconfig, I can see "Sandpoint X3" and "8260" selections, but no 8240 specific selections.
What options should I select to enable 8240 support? I am guessing "Sandpoint X3", is this right? The board is a custom 8240, with Ethernet and SCSI PCI chipsets, but no serial or ISA components. We have previously gotten a 2.3.16 kernel to work on it.
The Processor Type option text for CONFIG_6xx is wrong. It should say 82xx instead of 8260. Select 6xx/7xx/74xx/8260 for now since you have a "classic PPC" core.
Sandpoint is a board. It does not "enable" 8240 support. An 8240 is more or less a 603e + MPC10x bridge for software purposes. Add an entry for your custom board and use mpc10x_common.c like other examples in 2_4_devel.
Regards,
--
Matt Porter
MontaVista Software, Inc.
[email protected]
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/