audiowerk2
Quoted 5 lines
Quoted 3 lines
I have an AudiowerksII from Emagic. I was wondering what steps I could take to get this supported by Alsa. I have some programming experience but have never worked on device drivers before. I have contacted
Emagic.
Quoted 1 line
What Next?
Have Emagic supplied you with the specifications? You can download the specs on the SAA7146 from Philips. The Audiowerk2 is very much like the Audiowerk8, with some differences on the I/O and it also doesn\\\\\\\'t have the variable sample
rate.
There is an Audiowerk8 driver for Linux at
http://www.landamore.com/audiowerk.html . It is based on a GPL (example) driver
from Emagic.
If you did not receive any specs from Emagic, ask again. The documentation I have does not say anything about the Audiowerk2 and allthough it is very similar to the Audiowerk8 it will be different in setting the sample rate and use of the I2S (different time slot list) interface.
Quoted 3 lines
if you got a hardware spec, then take a look at the sources already existing. there are likely drivers with the similar chip design. then copy it, and modify it.
The SAA7146 has 2 input and 2 output DMA channels that can use non-contiguous (it has a MMU) buffers with \\\\\\\'any\\\\\\\' number of periods per buffer.
Quoted 3 lines
also, it would be better to ask Emagic whether the spec can be put on a public place, so that other developers can be involved with the development.
I doubt they will do this. I can put the documentation that I have on my website next week.
Quoted 6 lines
AFAIK the card is pretty much unique....
The main logic chip is a
PHILIPS
SAA 7146A HZ
CA1950.0
ktD9917V2
It is used in some video boards (, that probably don\\\\\\\'t use the audio part
of the chip).
I am (slowly) working on a Audiowerk8 driver and when it is usable I\\\\\\\'ll put
that on my website also.
--martijn
Powered by ASHosting
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Two, two, TWO treats in one.
http://thinkgeek.com/sf