53c1010 controller / LF-D200 DVD-RAM causes system lag

Hello,

I have been experiencing some annoying behavior with an LF-D200 DVD-RAM on my Tekram SCSI controller (SYM53c1010 chipset). I have tried all I can think of except different combinations or hardware which I don't have available. I have been unable to find any information this issues when searching the web.

Problem: During heavy access, the entire system becomes "lagged". System CPU usage goes up (load skyrockets); keypresses and keyreleases are missed (missed interrupts?). This happens mostly in bursts, although key events are missed constantly when this happens.

The problem is most pronounced when accessing a filesystem on the DVD-RAM; but also present when writing data to the device directly.

It does not always happen. I can write a few megs with no problem. Even tens or hundreds of megs. My best guess at the moment is that I start seeing problems when the fs cache fills up and it flushes data to the disk. It does *not* consistently occur when sync:ing though (i.e. I can write, say, 10 meg and do a sync without any noticable problems).

Also, as far as I know (but I am not certain) I can write any amount of data to the disk without problems while sync:ing once every 10 seconds or so - assuming the input is coming in more slowly than the speed of the DVD-RAM. I have not experimented a lot with this, but it was my initial observation when writing a tarball to the drive through netcat.

I have tried a few different kernels; most recently 2.4.19. I have tried both version 1 and 2 of the sym53c8xx driver.

I have a number of SCSI disks, one CD-ROM and one CD-burner on the controller. None of them exhibit any of these problems; it's just the DVD-RAM.

The drive shows up as a CD-ROM device (/dev/scd*), and NOT as a regular disk (/dev/sd*). Wheather this is correct I do not know; but I do know that at least some other DVD-RAM:s show up as disks (based on what I've read in HOWTOs).

As far as I have been able to tell I do not have any problems with cabling, SCSI resets, etc. AFAIK the symptomes are not consistent with such problems either.

Could this be a kernel problem? If so, what can I do to help debug it? What other information should I provide?

Thank you,

/ Peter Schuller, InfiDyne Technologies HB

PGP userID: 0xE9758B7D or 'Peter Schuller <[email protected]>'
Key retrival: Send an E-Mail to [email protected]
E-Mail: [email protected] Web: http://www.scode.org