Skip to contentSkip to conversation

problem with sundance driver for dfe-550fx (DL10050B)

DISCUSSION zhengchuanbo 1 participant 1 message Sep 11, 2002

lore
Share & tools
lore
#0 lore raw

i tried to test the dfe-550fx card with the new driver from Donald Becker. the version is "sundance.c:v1.09a 7/16/2002". the chip of the d-link card is DL10050B. a DL10050A card work with the v1.02d driver. but there are some problems with the DL10050B one. the kernel version is 2.4.19pre1.
i run the following commands:
insmod pci-scan.o
insmod sundance.o
and it worked. the log is as follows:

Sep 11 21:20:58 netpower kernel: pci-scan.c:v1.10 7/13/2002  Donald Becker <beck
[email protected]> http://www.scyld.com/linux/drivers.html
Sep 11 21:21:01 netpower kernel: sundance.c:v1.09a 7/16/2002  Written by Donald
Becker <[email protected]>
Sep 11 21:21:01 netpower kernel:   http://www.scyld.com/network/sundance.html
Sep 11 21:21:01 netpower kernel: eth2: OEM Sundance Technology ST201 at 0xe800,
00:05:5d:5e:b9:dc, IRQ 24.
Sep 11 21:21:01 netpower kernel: eth2: MII PHY found at address 1, status 0x7809
 advertising 01e1.
Sep 11 21:21:01 netpower kernel: eth3: OEM Sundance Technology ST201 at 0xe400,
00:05:5d:5e:b9:df, IRQ 22.
Sep 11 21:21:01 netpower kernel: eth3: MII PHY found at address 1, status 0x7809
 advertising 01e1.

then when i run the cmd "ifconfig eth2 192.168.0.10" to bring the card to work,it failed. the problem is as follows,

	sh-2.03# ifconfig eth2 192.168.0.10
	SIOCSIFFLAGS: No such device

and there is no log for this. so is there some problem on the support of DL10050B?

please cc. thanks.

zhengchuanbo
[email protected]