serial console
Hi all,
I am almost scared to ask this question, but I really dont have any other alternatives.
HP VISUALIZE - J2240
latest source
latesst gcc
kernel config - basic
In any case I have the latest compilers and the latest source. I have gone through the booting howto and have successfully switched my console. Yet I cannot get any messages after :
Branching to kernel entry point....
The make palo went fine, at which time i added my ramdisk and what not. I suspect it has something to do with my kernel since I have gotten the lifimage from debian and it works without a problem.
I must be missing something here, any help anyone could provide would be greatly appreciated.
Thanks,
Signature · 5 lines
Aaron St. Pierre tel: 978.828.6177 [email protected] Wow, I'm being shot at from both sides. That means I *must* be right. :-) -- Larry Wall in <[email protected]>