Skip to contentSkip to conversation

2.5.64-mm6

DISCUSSION Felipe Alfaro Solana 2 participants 2 messages Mar 13, 2003 – Mar 14, 2003 Memory management

lore
Share & tools
lore
#0 lore raw

----- Original Message -----
From: Thomas Molina <[email protected]>
Date: Thu, 13 Mar 2003 14:35:18 -0600 (CST)
To: Andrew Morton <[email protected]>
Subject: Re: 2.5.64-mm6

Quoted 10 lines

I downloaded the mm-6 patch and a pristine 2.5.64 tarball. After applying the patch I compiled with the standard configuration I've been using all along. No problems were noted during the compile cycle. During bootup the system locked up at the point where it did a modprobe uhci-hcd for the USB controller. Nothing of interest was noted in the log. I rebooted with nousb in the command line and got a good boot. After working with this kernel for awhile I don't see anything out of the ordainary except that on a 2.5.64-bk kernel I get 330 Kbytes per second download speed whereas with mm6 I get 280 Kbytes per second. Several runs show this is fairly consistent, with results within one or two percent.

Hmmm... I have experienced some hard locks similar to what you describe: if I compile usb-uhci as a module, Phoebe3 (8.0.94) locks hard at the time of doing a "modprobe usb-controller" (being usb-controller an alias for uhci-hcd) during boot (rc.sysinit script). To fix this, I have had to compile usb-uhci in to the kernel and then fix rc.sysinit. I haven't tried using usb-uhci as a module since then.

What's curious is that doing a "modprobe usb-controller" by hand doesn't cause hard locks. So, there must be some kind of timing or interaction that's causing rc.sysinit to invoke "modprobe uchi-hcd" and freeze the machine. Any ideas?

Felipe

Signature · 5 lines
______________________________________________
http://www.linuxmail.org/
Now with e-mail forwarding for only US$5.95/yr

Powered by Outblaze
#1 lore raw
Quoted 8 lines

Hmmm... I have experienced some hard locks similar to what you describe: if I compile usb-uhci as a module, Phoebe3 (8.0.94) locks hard at the time of doing a "modprobe usb-controller" (being usb-controller an alias for uhci-hcd) during boot (rc.sysinit script). To fix this, I have had to compile usb-uhci in to the kernel and then fix rc.sysinit. I haven't tried using usb-uhci as a module since then.

Quoted 4 lines

What's curious is that doing a "modprobe usb-controller" by hand doesn't cause hard locks. So, there must be some kind of timing or interaction that's causing rc.sysinit to invoke "modprobe uchi-hcd" and freeze the machine. Any ideas?

Not sure. The configuration I used to build 2.5.64-mm6 was the same as every other 2.5 build I've used recently. All of those included modular usb, so I don't believe it is that. In my case 2.5.64-mm6 is the only version on which I see this. My initial SWAG was some interaction between the new pcmcia core and usb, possibly at the pci layer. I only ever try very few mm kernel versions, so I don't have a whole lot of data at the moment.