USB-UHCI Fatal Error for all 2.5 kernels and 2.5.75 in RedHat v9.0 (fwd)
----------Forwarded message ----------
References: <[email protected]>
<[email protected]>
In-Reply-To: <[email protected]>
From: [email protected]
To: Greg KH <[email protected]>
Subject: Re: USB-UHCI Fatal Error for all 2.5 kernels and 2.5.75 in RedHat v9.0
Date: Fri, 11 Jul 2003 00:01:30 -0600
Mime-Version: 1.0
Content-Type: text/plain; format=flowed; charset="iso-8859-1"
Content-Transfer-Encoding: 7bit
X-Sender: [email protected]
X-Originating-IP: [12.249.189.237]
Quoted 7 lines · Greg KH
Quoted 2 lines · On Thu, Jul 10, 2003 at 07:29:47PM -0600, [email protected] wrote:
For soem reason right after the boot of the 2.5 kernels right when the INIT starts the USB-UHCI fails for the HID devices.
Exactly what error are you getting in the kernel log?
greg k-h
Could not find a Log specific for the INIT:
Looked in /var/log
I just carefully read the error and now figured out why its FATAL.
It cannot find the usb-uhci.o module
I looked in /lib/modules/kernel/drivers/usb and it is no where to be found.
It is configured in the kernel I checked and double checked.
I tried it as module and as monolithic and either way I get "FATAL" during the INIT: part of the bootup for usb.
Why isn't the kernel source package configuring the usb-uhci module correctly?
This is for all the kernels I have tested from 2.5.72 and up to 2.5.75.
I figured out why I am getting the error with "devpts". It is not supported in the 2.5 kernel's or I just cannot find it.
the UNIX TY98 /dev/pts. I found it for the 2.4 kernels but not for the 2.5 so that explains why I am getting the error mounting fs for pts.
The Penguin logo is broken again for 2.5.75. It was working for 2.5.74-mm2 and mm3.
As a matter of fact mm2 fixed the vesa issue and it was at that point I was able to get the penguin logo again, but stooped for 2.5.75.
Weird how things get fixed then other things that worked get broken.
Quoted 4 lines · On Fri, Jul 11, 2003 at 12:27:56AM -0600, [email protected] wrote:
I just carefully read the error and now figured out why its FATAL.
It cannot find the usb-uhci.o module
The module is now called uhci-hcd.o, not usb-uhci.o
I guess this should be in Dave's document, I'll go send him email about that...
Hope this helps,
greg k-h