i2c-proc module
I2C wants an i2c-proc module, but I can't find where to config it. Something like this happens when I run sensors:
/proc/sys/dev/sensors/chips or /proc/bus/i2c unreadable; Make sure you have done 'modprobe i2c-proc'!
There was an i2c-proc module with lm_sensors 2.7.0. What am I missing?
Andy Johnson
Quoted 10 lines · Andrew S. Johnson
I2C wants an i2c-proc module, but I can't find where to config it. Something like this happens when I run sensors:
/proc/sys/dev/sensors/chipsor/proc/bus/i2cunreadable; Make sure you have done 'modprobe i2c-proc'!There was an i2c-proc module with
lm_sensors2.7.0. What am I missing?Andy Johnson
lm_sensors uses sysfs now. Not proc. Sensors hasn't been updated. You'll have to use cat.
Quoted 7 lines · Ed Sweetman
Quoted 6 lines · Andrew S. Johnson
I2C wants an i2c-proc module, but I can't find where to config it. Something like this happens when I run sensors:
/proc/sys/dev/sensors/chipsor/proc/bus/i2cunreadable; Make sure you have done 'modprobe i2c-proc'!
Quoted 8 lines
Quoted 4 lines
There was an i2c-proc module with
lm_sensors2.7.0. What am I missing?Andy Johnson
lm_sensorsuses sysfs now. Not proc. Sensors hasn't been updated. You'll have to use cat.
It seems that by trial and error I figured it out. There's a i2c-dev module that I have to load first, then via686a, then i2c-isa. This order is different than with lm_sensors under 2.4 kernels. Also, the i2c-viapro was required before, but now it doesn't seem to do anything.
Thanks for helping,
Andy Johnson