Skip to contentSkip to conversation

DINK32 R13.1 on Sandpoint X2

DISCUSSION Yuxiao Xi 1 participant 1 message Sep 5, 2003

lore
Share & tools
lore

Yuxiao Xi

author
#0 lore raw

hi,
I succeed in downloading my linux kernel image using DINK32 r13.1
tftp function to my Sandpoint X2 board. Before I used ftp servers which need user name and password and I could not download anything.Today I use Cisco ftp server which needs nothing and I succeed.

But there are another question yet: when I use command 'ping', to
ping my target from the host,I get info:destination address unreachable to ping my host from the target��It's OK why?

Quoted 31 lines

We have an 8139 and have successfully downloaded and run a kernel with DINK version 13.1.1. I didn't do it but the instructions sent from the person who did are:

To download via the network, DINK uses fixed IP address and Realtek8139 NIC. The steps are:

   1. do "ppr" verify NIC card has been identified vendor/device ID as
   10EC/8139
   2. do "env IO=COM1:9600@100, Then "reset".
   3. do "ni -i " to set up your network parameters.  For example:

    DINK32[MPC7457] {1} >>ni
    NETWORK INFORMATION
      PCI CARD
        Type 8139/10EC on slot 16

      SETTINGS
        SERVER(TFTP) : 192.168.  1.  1
        GATEWAY      : 192.168.  1.  1
        NETMASK      : 255.255.255.  0
        DHCP         : 192.168.  1.  1
        CLIENT(DINK) : 192.168.  1.  7

      DHCP: Disabled
      SESSION TIMEOUT: Never

   4. set up you tftp server at host side
   5. The download command is "dl -nw -b -o800000 -fzImage.sandpoint"
   6. "go 810000"
Quoted 25 lines

You can change IP addr, image name, to fit your setup.

As far as differences in the X2 vs. X3, yes there are important differences. Does DINK v13.1.1 run successfully & download via the network successfully on an X2? I don't know, you'll have to figure that out for yourself or talk to Motorola.

Quoted 18 lines

From the mailing lists,I know that someone use DINK32's tftp
download function to download his image successfully on a Sandpoint X3 board.Is there any important differences between Sandpoint X3 and X2 board so that I can not use the DINK32's tftp function on X2 board?

======= 2003-09-03 11:04:00 ��=======

Quoted 11 lines · Yuxiao Xi
Quoted 6 lines

Now I'm working on a Motorola Sandpoint X2 board with ppc8240.
I use DINK32 r13.1 to boot my linux kernel image. From DINK32 r13.1 user manual,I know that DINK32 r13.1 supports ethernet card Realtek 8139,but after these steps:

What I would suggest is that instead of using the ethernet card support, you use the serial support still. DINK32 r13.0.0 and newer support 115200 baud, so loading a kernel via serial is now much less painful than it used to be.

= = = = = = = = = = = = = = = = = = = =

����������������Yuxiao Xi
����������������[email protected]
��������������������2003-09-05

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/