Skip to contentSkip to conversation

BugReport: USB (ACPI), E100, SWSUSP problems (test5 vs. test3)

DISCUSSION Tom Winkler 2 participants 2 messages Sep 10, 2003

lore
Share & tools
lore
#0 lore raw

Hello,

I recently updated my kernel on my laptop (Sony Vaio FX403, i815 chipset, PIII 1GHz CPU) from 2.6.0test3 to 2.6.0test5 (I skipped test4). I used the same .config for test5 as for test3.

test5 (or already test4) introduced some problems that were not there in test3:

- USB is totally dead
This notebook has some IRQ routing problems and requires ACPI to get it
right. When using older 2.4 Kernels I always had to apply the ACPI patches to get USB working. Because of that I suspect that the problems with test5 might be ACPI related as well.

- The e100 driver seems to be broken
The NIC is detected correctly and ifconfig shows eth0 as usually. But for
some reason not a single Byte seems to go over the NIC.

- SWSUSP
In test5 there is no /proc/acpi/sleep
In test3 suspend to disk (and resume) works in "console only" mode.
Suspending from X11 works too but resuming hangs. The last message that gets displayed is "Waiting for DMAs to settle down...". At this point the machine seems to freeze completely.
Remark: I had SWSUSP working on this very same machine with older 2.4 kernels and seperat SWSUSP patches. It never worked with 2.6 so far.

full dmesg: http://www.wnk.at/tmp/test5/dmesg-2.6.0test5.txt
.config used building the kernel: http://www.wnk.at/tmp/test5/config.txt

Since I'm not subscribed to LKM please CC me on replys.

Thanks,

Signature · 2 lines
Tom Winkler
e-mail: [email protected]
#1 lore raw

Hi!

Quoted 8 lines

- SWSUSP
In test5 there is no /proc/acpi/sleep
In test3 suspend to disk (and resume) works in "console only" mode.
Suspending from X11 works too but resuming hangs. The last message that gets displayed is "Waiting for DMAs to settle down...". At this point the machine seems to freeze completely.
Remark: I had SWSUSP working on this very same machine with older 2.4 kernels and seperat SWSUSP patches. It never worked with 2.6 so far.

Test again in -test6 or -test7. Big changes are now going on.

Or take -test3 and try to find out which hardware driver needs to be unloaded in order for swsusp to work.

Pavel

Signature · 2 lines
When do you have a heart between your knees?
[Johanka's followup: and *two* hearts?]