Linux <---> Unixware slow networking with e100
Subsystems (2)
Hello everybody,
we have a little problem here with networking between linux (redhat AS 2.1 2.4.9-e.27smp) and unixware 7.1.1 . The network card is a Intel 82557 Ethernet Pro 100 (lspci output) on a 100 mbit network. When doing data transfers between two linux machines, everything works fine, we have transfer rates of about 10 MB/s. But when _receiving_ data from one of the unixware machines, we just get a few kB/s, max. about 100 kB/s. When _sending_ data to a unixware machine, the transfer rate is fine too. Are there any known issues between linux and unixware (except the SCO thing ;-) ) ??
At first we used the eepro100 driver, but this gave us poor performance on receive with every other machine, whether it was unixware or linux.
Another thing on that machine is, that there's a Intel 82544GC copper gigabit card in it. When using this one with the e1000 driver, it also gave us bad performance on receive (also just around max. 100 kB/s). Maxbe there are some options for module loading for the e1000 driver??
Thanks in advance for any tips!!!
Sven
Quoted 5 lines · Sven Schuster
But when _receiving_ data from one of the unixware machines, we just get a few kB/s, max. about 100 kB/s. When _sending_ data to a unixware machine, the transfer rate is fine too. Are there any known issues between linux and unixware (except the SCO thing ;-) ) ??
Run tcpdump and see what the window sizes are when sending data from Unixware to Linux.
Signature · 2 lines
Regards, Rask Ingemann Lambertsen
Quoted 10 lines · Rask Ingemann Lambertsen
Quoted 6 lines · Sven Schuster
But when _receiving_ data from one of the unixware machines, we just get a few kB/s, max. about 100 kB/s. When _sending_ data to a unixware machine, the transfer rate is fine too. Are there any known issues between linux and unixware (except the SCO thing ;-) ) ??
Quoted 3 lines
Run tcpdump and see what the window sizes are when sending data from Unixware to Linux.
This actually seems to be a problem with either a switch in the network or with the onboard intel network card. I think it's one of the switches, or maybe the combination of those (one Planet FN-SW102 100 Mbit and one Foundry B15000 with the ports of our machines running at 100 Mbit), because we have the same slow transfer rates in this network from unixware to unixware. I did some tests yesterday directly from a redhat AS 2.1 to a unixware machine via cat. 7 crossover, and I didn't have any problems. And over a Planet switch (100 Mbit) there also were no problems.
But thanks for your tip!! I'll get back and report what the issue was for the archives.
Sven