serverworks usb under 2.4.22
Quoted 7 lines
From: Brian Beattie <[email protected]>
Date: Thu, 13 Nov 2003 19:17:02 -0500
...
I've got a system with a Super Micro P3 dual processor board. This board uses the Serverworks chipset and the 2.4.22 kernel is unable to allocate an IRQ when initializing the USB (usb-ohic) interface. This board works fine under 2.4.20 and 2.4.21.
Transcript of kernel messages...?
Quoted 9 lines · On Thu, 2003-11-13 at 20:24, [email protected] wrote:
Quoted 7 lines
From: Brian Beattie <[email protected]>
Date: Thu, 13 Nov 2003 19:17:02 -0500
...
I've got a system with a Super Micro P3 dual processor board. This board uses the Serverworks chipset and the 2.4.22 kernel is unable to allocate an IRQ when initializing the USB (usb-ohic) interface. This board works fine under 2.4.20 and 2.4.21.Transcript of kernel messages...?
from dmesg:
usb.c: registered new driver hubhost/usb-uhci.c: $Revision: 1.275 $ time 09:19:46 Nov 14 2003 host/usb-uhci.c: High bandwidth mode enabled host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver host/usb-ohci.c: USB OHCI at membase 0xf88a8000, IRQ -19 host/usb-ohci.c: usb-00:0f.2, ServerWorks OSB4/CSB5 OHCI USB Controller usb.c: new USB bus registered, assigned bus number 1 host/usb-ohci.c: request interrupt -19 failedusb.c: USB bus 1 deregistered
from lspci
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 USB Controller (rev 04) (prog-if 10 [OHCI])
Subsystem: ServerWorks: Unknown device 0220
Flags: medium devsel, IRQ -19
Memory at fcafe000 (32-bit, non-prefetchable) [size=4K]
Signature · 6 lines
Brian Beattie | Experienced kernel hacker/embedded systems [email protected] | programmer, direct or contract, short or www.beattie-home.net | long term, available immediately. "Honor isn't about making the right choices. It's about dealing with the consequences." -- Midori Koto