Skip to contentSkip to conversation

Problem Report: 2.4.23-rc2, ide, dma settings

DISCUSSION Stephan von Krawczynski 1 participant 1 message Nov 23, 2003

lore
Share & tools
lore
#0 lore raw

Hello all,

I just found out that either I did not understand what the "keepsettings" flag in hdparm is meant to be, or it does not work as expected. Situation is as follows:

Trying to record DVDs with a SONY DRU-500A connected to

00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 93)

I do "hdparm -k1 -d1 /dev/hdc" and see:

/dev/hdc:
setting using_dma to 1 (on)
setting keep_settings to 1 (on)
using_dma = 1 (on)
keepsettings = 1 (on)

Then I try recording, but something bad happens:

Nov 23 16:36:50 box kernel: scsi : aborting command due to timeout : pid

5977459, scsi3, channel 0, id 0, lun 0 UNKNOWN(0x54) 01 00 00 00 00 00 00 00 00

Nov 23 16:36:50 box kernel: hdc: irq timeout: status=0xd0 { Busy }
Nov 23 16:36:50 box kernel: hdc: ATAPI reset complete

And after that:

# hdparm /dev/hdc

/dev/hdc:
HDIO_GET_MULTCOUNT failed: Invalid argument

 IO_support   =  0 (default 16-bit)
 unmaskirq    =  0 (off)
 using_dma    =  0 (off)
 keepsettings =  1 (on)
 readonly     =  0 (off)

BLKRAGET failed: Invalid argument
HDIO_GETGEO failed: Invalid argument

DMA is off. Is this expected? Recording btw _continues_, only without DMA. This happens during high load situations...

Regards,
Stephan