Skip to contentSkip to conversation

Selecting CPU frequency on Asus P4M laptop

DISCUSSION Måns Rullgård 2 participants 4 messages Nov 27, 2003

lore
Share & tools
lore
#0 lore raw

I have an Asus M2E laptop with a 1.8 GHz P4M CPU. Using the 'acpi' cpufreq driver, I can select between 1.8 GHz and 1.2 GHz, thereby changing the power consumption. If I boot the machine with the AC adapter disconnected, it starts off at 1.2 GHz. After that, I can lower it to 800 MHz using cpufreq. In short, cpufreq will be able to choose among one of two pairs of frequencies, which depend on the status of the AC adapter at boot time.

Is there any way to change which of these will be used after booting?

Signature · 2 lines
Måns Rullgård
[email protected]
#1 lore raw
Quoted 1 line · On Thursday November 27th 2003 Måns Rullgård wrote:

Is there any way to change which of these will be used after booting?

Have you already tried (as a module, *not* builtin) the SpeedStep clockmod driver (CONFIG_X86_P4_CLOCKMOD=M) or, if your Southbridge is an ICH[234], the ICH driver (CONFIG_X86_SPEEDSTEP_ICH=M)?

You might then always have access to the maximum speed, and reduce according to need of usage to something lower.

Signature · 1 line
Marco Roeland
#2 lore raw
Quoted 7 lines · Marco Roeland
Quoted 1 line · On Thursday November 27th 2003 Måns Rullgård wrote:

Is there any way to change which of these will be used after booting?

Have you already tried (as a module, *not* builtin) the SpeedStep clockmod driver (CONFIG_X86_P4_CLOCKMOD=M) or, if your Southbridge is an ICH[234], the ICH driver (CONFIG_X86_SPEEDSTEP_ICH=M)?

I've tried them all. Only acpi and p4-clockmod load successfully.

Signature · 2 lines
Måns Rullgård
[email protected]
#3 lore raw
In reply to Måns Rullgård
Quoted 9 lines · [email protected] (Måns Rullgård) writes:

I have an Asus M2E laptop with a 1.8 GHz P4M CPU. Using the 'acpi' cpufreq driver, I can select between 1.8 GHz and 1.2 GHz, thereby changing the power consumption. If I boot the machine with the AC adapter disconnected, it starts off at 1.2 GHz. After that, I can lower it to 800 MHz using cpufreq. In short, cpufreq will be able to choose among one of two pairs of frequencies, which depend on the status of the AC adapter at boot time.

Is there any way to change which of these will be used after booting?

Update:

I ran a speed test, "openssl speed", in the various modes, and it gave the same results whichever way the machine was booted. It appears to be reporting/detecting incorrect values when the AC adapter is unplugged. Switching speeds with cpufreq does change the actual speed of the CPU.

Signature · 2 lines
Måns Rullgård
[email protected]