HPT366 not booting with 2.6.0tests
I've been trying to get one of the 2.6.0-test kernels to work for a while now and have been having no luck.
Latest attempt was that I compiled 2.6.0-test11. I compiled in ext3 and HPT366/37. My root partition is /dev/hde1 and is ext3. The kernel boots and recognizes the HPT366 controller just fine, but it doesn't actually ackknowledge ide2 and ide3 as it should. It only sees ide0 and ide1. This results in a kernel panic:
Kernel panic: VFS: Unable to mount root fs on unknown-block(33,1)
This has been working fine with 2.4.20. I tried coping the .config directly and doing "make oldconfig". I've started from scratch. I've toyed with booting off-board chipsets first (which doesn't seem to apply anyway), and I'm just stumped at this point. Any ideas?
this is an Abit BP6 dual Celeron system./dev/hda is ide-cdrom (seen at boot)/dev/hdb is ide-scsi zip-drive/dev/hdc is ide-scsi cdwriter (seen at boot)/dev/hdd is an ide-disk/dev/hde is an ide-disk
(attached is my .config)
Thanks in advance for any help. :)
Signature · 1 line
Rahsheen Porter <[email protected]>
Quoted 10 lines · Rahsheen Porter Sr.
I've been trying to get one of the 2.6.0-test kernels to work for a while now and have been having no luck.
Latest attempt was that I compiled 2.6.0-test11. I compiled in ext3 and HPT366/37. My root partition is
/dev/hde1and is ext3. The kernel boots and recognizes the HPT366 controller just fine, but it doesn't actually ackknowledge ide2 and ide3 as it should. It only sees ide0 and ide1. This results in a kernel panic:Kernel panic: VFS: Unable to mount root fs on unknown-block(33,1)
Been there, done that, even bought the T-shirt...
That error here has historically been a typu in the lilo.conf or grub.conf, wrong pointer to the / filesystems partition.
So check your root(hd0:0) line. Compare it with a good boots setting.
Quoted 15 lines
This has been working fine with 2.4.20. I tried coping the .config directly and doing "make oldconfig". I've started from scratch. I've toyed with booting off-board chipsets first (which doesn't seem to apply anyway), and I'm just stumped at this point. Any ideas?
this is an Abit BP6 dual Celeron system.
/dev/hdais ide-cdrom (seen at boot)/dev/hdbis ide-scsi zip-drive/dev/hdcis ide-scsi cdwriter (seen at boot)/dev/hddis an ide-disk/dev/hdeis an ide-disk(attached is my .config)
Thanks in advance for any help. :)
Signature · 7 lines
Cheers, Gene AMD K6-III@500mhz 320M Athlon1600XP@1400mhz 512M 99.27% setiathome rank, not too shabby for a WV hillbilly Yahoo.com attornies please note, additions to this message by Gene Heskett are: Copyright 2003 by Maurice Eugene Heskett, all rights reserved.