ieee1394 / sbp2 problem accessing iBook in target disk mode
Hi,
I tried to access another iBook in target disk mode via the sbp2 driver running a 2.4.22-benh2 kernel. The device (the other iBook) is detected but can not ba accessed properly:
ohci1394: $Rev: 1010 $ Ben Collins <[email protected]>ohci1394_0: Unexpected PCI resource length of 1000!ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[40] MMIO=[f5000000-f50007ff] Max Packet=[2048]
ieee1394: Node added: ID:BUS[0-00:1023] GUID[000a95fffeea7b48]
ieee1394: Host added: ID:BUS[0-01:1023] GUID[000a95fffea13034]
ieee1394: unsolicited response packet received - np
ieee1394: contents: ffc10120 ffc07000 00000000 9ce61184
sbp2: $Rev: 1010 $ Ben Collins <[email protected]>
scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
blk: queue e5fb0014, I/O limit 4095Mb (mask 0xffffffff)
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048] scsi singledevice 3 0 0 0
scsi singledevice 1 0 0 0
Vendor: AAPL Model: FireWire Target Rev: 0000
Type: Direct-Access ANSI SCSI revision: 03
blk: queue e5e0e214, I/O limit 4095Mb (mask 0xffffffff) Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
ieee1394: sbp2: aborting sbp2 command0x00 00 00 00 00 00
sda: Unit Not Ready, sense:
Current 00:00: sns = 70 2
ASC=3a ASCQ= 0
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Current sd00:00: sns = 70 2
ASC=3a ASCQ= 0
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
/dev/scsi/host1/bus0/target0/lun0: I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 0
unable to read partition table
Of course it works under MacOS-X and also networking via the eth1394 driver is working nicely between the two Linux iBooks.
Is this problem know or any ideas?
Sincerely yours,
René Rebe
- ROCK Linux stable release maintainer
Signature · 4 lines
René Rebe - Europe/Germany/Berlin [email protected] [email protected] http://www.rocklinux.org http://www.rocklinux-consulting.de http://gsmp.rocklinux-consulting.de/ http://gsmp.tfh-berlin.de/rene
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi,
Quoted 11 lines
Quoted 11 lines
sbp2: $Rev: 1010 $ Ben Collins <[email protected]>
scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
blk: queuee5fb0014, I/O limit 4095Mb (mask0xffffffff)
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048] scsi singledevice 3 0 0 0
scsi singledevice 1 0 0 0
Vendor: AAPL Model: FireWire Target Rev: 0000
Type: Direct-Access ANSI SCSI revision: 03
Using a LaCie Firewire disk the sbp2 code works perfectly:
ohci1394: $Rev: 1010 $ Ben Collins <[email protected]>ohci1394_0: Unexpected PCI resource length of 1000!ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[40] MMIO=[f5000000-f50007ff] Max Packet=[2048]
ieee1394: Host added: ID:BUS[0-00:1023] GUID[000393fffeb0203a]
ieee1394: Node added: ID:BUS[0-01:1023] GUID[00d04b3b030766bf]
ieee1394: The root node is not cycle master capable; selecting a new root node and resetting...
ieee1394: Node changed: 0-01:1023 -> 0-00:1023
ieee1394: Node changed: 0-00:1023 -> 0-01:1023
sbp2: $Rev: 1010 $ Ben Collins <[email protected]>
scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
blk: queue c5e0e814, I/O limit 4095Mb (mask 0xffffffff)
ieee1394: sbp2: Logged into SBP-2 device
ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload [2048]
scsi singledevice 1 0 0 0
Vendor: WDC WD16 Model: 00BB-00DWA0 Rev: 15.0
Type: Direct-Access ANSI SCSI revision: 06
blk: queue c45bbc14, I/O limit 4095Mb (mask 0xffffffff)
Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
/dev/scsi/host1/bus0/target0/lun0: p1 p2
$ cat /proc/bus/ieee1394/devices
Node[0-00:1023] GUID[00d04b3b030766bf]:
Vendor ID: `LaCie ' [0x00d04b]
Capabilities: 0x0083c0
Bus Options:
IRMC(0) CMC(0) ISC(0) BMC(0) PMC(0) GEN(0)
LSPD(2) MAX_REC(64) CYC_CLK_ACC(255) Unit Directory 0:
Vendor/Model ID: LaCie [00d04b] / LaCie Hard Drive Firewire [000001]
Software Specifier ID: 00609e
Software Version: 010483
Driver: SBP2 Driver
Length (in quads): 8
Sincerely yours,
René Rebe
- ROCK Linux stable release maintainer
Signature · 4 lines
René Rebe - Europe/Germany/Berlin [email protected] [email protected] http://www.rocklinux.org http://www.rocklinux-consulting.de http://gsmp.tfh-berlin.de/gsmp http://gsmp.tfh-berlin.de/rene