Skip to contentSkip to conversation

Sis900 ethernet dropping 70% packets

DISCUSSION Andrew Walrond 2 participants 2 messages Dec 14, 2003 – Dec 15, 2003

lore
Share & tools
lore
#0 lore raw

I'm trying to install a little Via C3 machine with on-board Sis900 ethernet. As usual, I booted my LNX-BBC rescue disk, configured eth0 and tried to scp my distro over, but failed miserably.

Pinging other hosts on the net sees 70-80% packets getting lost.

LNX-BBC rescue cd uses a 2.4.19 kernel

So then I tried a Trinity rescue disk, using a 2.4.21 kernel. Same thing.

Anybody got experience of this? Googling gives wads of people with similar sounding problems, mostly interrupt related, sometimes Vlan related (It's plugged into a Cisco catalyst but I tried a x-over cable to my laptop with the same result, so I don't think thats relevant), but don't see any solutions.

Is this a known-bad interface? The drivers sources don't seem to have been touched for a long time which makes me think its unlikely that a newer kernel would help, but who knows...

Any suggestions apprieciated

Andrew Walrond

#1 lore raw
Quoted 16 lines · Andrew Walrond

I'm trying to install a little Via C3 machine with on-board Sis900 ethernet. As usual, I booted my LNX-BBC rescue disk, configured eth0 and tried to scp my distro over, but failed miserably.

Pinging other hosts on the net sees 70-80% packets getting lost.

LNX-BBC rescue cd uses a 2.4.19 kernel

So then I tried a Trinity rescue disk, using a 2.4.21 kernel. Same thing.

Anybody got experience of this? Googling gives wads of people with similar sounding problems, mostly interrupt related, sometimes Vlan related (It's plugged into a Cisco catalyst but I tried a x-over cable to my laptop with the same result, so I don't think thats relevant), but don't see any solutions.

Quoted 3 lines

Is this a known-bad interface? The drivers sources don't seem to have been touched for a long time which makes me think its unlikely that a newer kernel would help, but who knows...

I can only say that my laptop has a sis900, and I've never had any problems with it. I'd look for errors elsewhere. Maybe it's ACPI related. ACPI seems to be able to screw up anything.

Signature · 2 lines
Måns Rullgård
[email protected]