Skip to contentSkip to conversation

Network problems with b44 in 2.6.0

DISCUSSION Michael Guntsche 1 participant 1 message Dec 29, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

Quoted 7 lines

As soon as I started the process, the following error messages started appearing in my syslog.

b44: eth0: Link is down.
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is on for TX and on for RX.
b44: eth0: Link is down.

I played around with various settings on my notebook and noticed that setting the link to 10BaseT-HD gave me a troughput of ~900KB/s. No error messages in syslog, but ifconfig is still showing lots of errors and collisions.

eth0 Link encap:Ethernet HWaddr 00:C0:9F:23:FA:FC

          inet addr:192.168.0.147  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:89558 errors:21031 dropped:0 overruns:0 frame:21031
          TX packets:65585 errors:0 dropped:0 overruns:0 carrier:26
          collisions:22559 txqueuelen:1000 
          RX bytes:99059807 (94.4 MiB)  TX bytes:3306603 (3.1 MiB)
          Interrupt:5 

I got this after copying 20 MB from the gateway to the notebook.

/Michael