TG3: very high CPU usage
A message that is not in the archive (sent off-list or not yet received): [email protected]
Mark Williams (MWP) wrote:
[...]
Quoted 2 lines
However, when using Apache or any FTP client/daemon, the TG3 driver appears to be VERY slow maxing out CPU usage at 100% while only transfering at around 12MB/sec. This applies for both incoming or outgoing data.
[...]
Quoted 1 line
Ive tried other NICs, etc and confirmed that it is a problem with the TG3 driver.
I saw the same problem with the bcm-driver (Kernel 2.4.x) shipped with SuSE 9 / SLES 8. Testcase was the initial mirror of a 10 GB partition on a raid5 serveraid / XSeries 235 (2 way) to the same hardware on the remote machine using both times the onboard NIC (Broadcom GBit Ethernet) via drbd:
100% CPU usage, 12 MB/s, machine is nearly death.
Regards,
Andreas Hartmann
Quoted 9 lines
Mark Williams (MWP) wrote:
[...]Quoted 4 lines
However, when using Apache or any FTP client/daemon, the TG3 driver appears to be VERY slow maxing out CPU usage at 100% while only transfering at around 12MB/sec.
This applies for both incoming or outgoing data.[...]
Quoted 8 lines
Quoted 2 lines
Ive tried other NICs, etc and confirmed that it is a problem with the TG3 driver.
I saw the same problem with the bcm-driver (Kernel 2.4.x) shipped with SuSE 9 / SLES 8. Testcase was the initial mirror of a 10 GB partition on a raid5 serveraid / XSeries 235 (2 way) to the same hardware on the remote machine using both times the onboard NIC (Broadcom GBit Ethernet) via drbd:
100% CPU usage, 12 MB/s, machine is nearly death.
Well im glad someone else also has this problem.
Any of the TG3 maintainers have an idea as to whats causing it?
Im handy with C, but nowhere near good enough to go hacking away at the driver. I would be happy to help test new drivers if needed.
Thanks.