Skip to contentSkip to conversation

JFS default behavior

DISCUSSION Pascal Schmidt 2 participants 2 messages Feb 16, 2004 2 messages not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#2 lore raw

On Mon, 16 Feb 2004 15:30:21 +0100, you wrote in linux.kernel:

Quoted 5 lines

When I do this, I still cannot enter unicode chars "as usual". I see them, mutt (for example) displays everything correct with a UTF-8 locale. However, I cannot insert them correctly. When I use vim, I have to press another key (eg. Space) 2..4 times after an umlaut was pressed, only then the char appears.

You're right, inputing UTF-8 (in joe) doesn't work, but that's an application problem, I think, because it works just fine on a shell prompt.

Signature · 2 lines
Ciao,
Pascal
#3 lore raw

Moin Pascal!
Pascal Schmidt schrieb am Monday, den 16. February 2004:

Quoted 9 lines
Quoted 5 lines

When I do this, I still cannot enter unicode chars "as usual". I see them, mutt (for example) displays everything correct with a UTF-8 locale. However, I cannot insert them correctly. When I use vim, I have to press another key (eg. Space) 2..4 times after an umlaut was pressed, only then the char appears.

You're right, inputing UTF-8 (in joe) doesn't work, but that's an application problem, I think, because it works just fine on a shell prompt.

No, does not work for me either (up-to-date bash). General multibyte support in joe is a different problem.

Regards,
Eduard.

Signature · 2 lines
Wie man sein Kind nicht nennen sollte: 
  Mario Hanna