TCP/IP via digi
Hello,
I wonder is it possible to establish tcp/ip over ax25 connection via an TheNet X-1J4 digipeater? Direct connection between my two machines works, but the gateway isn't reachable direct - only via digi.
I searched list archive, but found only question, not the answer...
regards, Alek
Signature · 1 line
73 de YU1IS -=- ICQ# 62419462
A message that is not in the archive (sent off-list or not yet received): [email protected]
Paul, Richard,
thanks for an express answer.
I'll give a try and announce the results.
Alek.
Signature · 1 line
73 de YU1IS -=- ICQ# 62419462
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hello Paul,
Quoted 2 lines
get the sysop of the x1j4 node to enable the IP stack on the node then you can use it as an ip router.
I've checked IP settings at x-1j4 node, and you was right. IP adress is in wrong range, and no route is set. The bizzare thing is, that people from radio-club who are maintaining digi haven't a clue about sysop password. They will try to find when and who programmed the EPROM's for them - Hi ! In between, is it any "factory-default" password for TheNet? I'm very much assured it is left as is. Would you look at your documentation once again?
It is all about 4N1ZNX gateway (of which I am co-sysop), and 4N1ZNI-6 digipeater on near hill. Those two are covering Nis area here in east Serbia since last autumn very solid.
regards,
Alek
Signature · 1 line
73 de YU1IS -=- ICQ# 62419462